Do you have a question about the Silo and is the answer not in the manual?
Questions and answers
Summary of Contents for DOMUSA TEKNIK Silo
Page 1
INSTALLATION AND OPERATING INSTRUCTIONS SILO...
Page 2
Thank you for choosing a DOMUSA TEKNIK product. From the range of DOMUSA TEKNIK products you have chosen the Silo. With a suitable installation and connected to a pellet boiler, this Silo will provide the ideal level of comfort for your home.
Keep children away while you are working in the pellet store. The Silo withstands UV rays but it should not be exposed directly to rain, and so it should not be installed outdoors, unless it is in a sheltered place. Neither should it be placed in direct contact with a damp wall, particularly the canvas.
Both the construction and the fire protection of the walls, roof and door of the premises used for the Silo and the boiler room must comply with the applicable local building and fire protection regulations. The base or floor the Silo stands on must be built to withstand at least 1600 kg at each point of support.
Page 7
Minimum dimensions of the premises: Example of installation of the Textile Silo in the same room of the boiler room: Installation of the Textile Silo in the same room as the boiler room: Installation of the Textile Silo in a separate room to...
Silo Fuel quality The Silo is exclusively designed and intended for storage of wood pellets with a diameter of 6 mm and a length of up to 40 mm. The wood pellets used must comply with the EN 14961-2 standard, class A1, at least, and be certified with one of the following quality marks: ENplus-A1, DINplus, NF Bois or equivalent.
50 mm. The following recommendations must also be complied with for correct installation: The maximum permitted hose length is 25 metres for conveyance from the main Silo to the suction unit (CVS suction system pot) and 25 metres for return.
CVS suction system. The Silo is specially designed to work as part of an installation with a plastic hose with an interior diameter of 50 mm. This hose must have a static electricity discharge system, preferably a copper wire wound around its entire length.
Connect the pneumatic suction system hoses as hoses must be earthed. The underside of the shown in the figure and fix them in place with the suction pot is designed for an earth connection clamps supplied with the Silo. terminal to be bolted to it.
The DOMUSA TEKNIK Silo is designed to be filled by a tank truck, through a flexible hose that pumps the pellets into the Silo. Tank trucks for pellet supply usually have a flexible hose of up to 30 metres, and the Silo should therefore be installed at a maximum distance of 30 metres from the nearest truck access point (if a longer distance is required, check with the pellet supplier whether longer hoses are available).
Silo 4.0 2050 5,1 – 6,4 3,0 – 4,1 Silo 5.0 2250 6,2 - 8 3,7 – 5,2 The Silo’s storage capacity will depend on the type, density and quality of the pellets used, and on the height of the premises.
Page 20
Bº San Esteban s/n 20730 AZPEITIA 20737 ERREZIL (Gipuzkoa) Tel: +34 943 813 899 Tel: (+34) 943 813 899 www.domusateknik.com DOMUSA TEKNIK reserves the right to make modifications of any kind to its *CDOC001698* product characteristics without prior notice. CDOC001698 10/17...
Need help?
Do you have a question about the Silo and is the answer not in the manual?
Questions and answers