21 inch aluminum deck
walk behind lawn mower (14 pages)
Summary of Contents for Saber Edge LM-22AHD
Page 1
�inding a dealer, or to register your product. Whenever you need service, genuine Saber Edge parts, or additional information, contact an Authorized Service Dealer or Saber Edge’s Customer Service and have the model and serial numbers of your product ready. Saber Edge Corporation www.saberturf.com...
Table of Contents Slope Gauge..................................3 Safety ....................................4 General Operation ................................4 Slope Operation ................................4 Children and Pets ................................5 Service....................................5 Safe Handling of Gasoline ............................5 General Service ................................5 Safety and Instructional Decals ..........................6 Product Overview ................................6 Setup ....................................6 Installing the Handle ..............................6 Installing the Recoil-starter Rope in the Rope Eyelet ..................7 Filling the Engine with Oil............................7 Filling the fuel Tank ...............................7...
Slope Gauge USE THIS SLOPE GAUGE TO DETERMINE IF A SLOPE IS TOO STEEP FOR SAFE OPERATION! To check the slope, proceed as follows: 1. Remove this page and fold along the dashed line. 2. Locate a vertical object on or behind the slope (e.g. a pole, building, fence, tree, etc.) 3.
• Do not pull machine backward unless absolutely necessary. Always look down and Safety Read and understand the contents of this manual behind before and while moving backward. before you start the engine. • Never direct discharged material toward anyone. Avoid discharging material against Obey all safety messages that follow this symbol a wall or obstruction.
• Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place Children and Pets containers on the ground away from your vehicle Tragic accidents can occur if the operator is not alert before filling.
Safety and Product Overview Blade control bar Instructional Decals Traction Clutch Bar Knob (4) Important: All damaged or illegible safety and instruction decals should be replaced. Grass Catcher They are located near areas of potential danger. Cutting Height Lever handle Safety Warning Label Danger Decal Setup...
• Fill the tank outdoors when the engine is cold. Wipe up spills. Installing the Recoil-starter • Do not handle gasoline when smoking or around an open flame or sparks. Rope in the Rope Eyelet • Store gasoline in an approved fuel container, Important: To start the engine safely and easily out of the reach of children.
First unlock the setting by pulling the leaver away from the mower out towards the right. You can now move the leaver either towards the front Forward Travel wheel (increasing the height) or back towards the rear bag (decreasing the height). Pull lever to handle and hold To travel forward = 7/8...
This will help direction and result in serious personal injury engine airflow and extend engine life. or death to the operator or bystanders. Check the grass bag frequently. If it is damaged, install a new Saber Edge replacement bag.
• Empty the fuel tank before repairs as directed and before annual storage. • Replace the blade or have it sharpened (more frequently if the edge dulls quickly) by an Authorized Saber Edge Dealer . Y early • Refer to your Engine Operator’s Manual for any additional yearly maintenance procedures.
4. After drain the used oil, return the machine to the normal operating position. Servicing the Air Cleaner 5. Slowly pour oil into the oil fill tube until the oil level reaches the FULL line on the dipstick. Do Service Interval: Every 25 hours/Yearly (whichever not over fill.
Preparing the Machine for Storage •Do not store gasoline more than 30 days. WARNING: Gasoline vapors can explode. •Do not store the machine in an enclosure near an open flame. Allow the engine to cool before storing it 1. On the last refueling of the year, add fuel stabilizer to the fuel as directed by the engine manufacturer.