GBC 68.0010.69/I User Manual page 4

Intro
The outdoor motion sensor is ideal to make automatic scenarios in case of motion detection. It is possible to connect the sensor to the
compatibles actuator micromodules that control the electric loads in the home (eg a light). The sensor can also be paired with the Smart WiFi
socket (code 68.0010.50/I) and it can be used as a security sensor, alerting the user by mail if it detects the motion.
Operating modes
Open the motion detector by unscrewing the four screws on the back of the device.
Learning with a compatible micromodule (max 10)
After installing a micromodule of the same series, this can be learned from the PIR sensor. To do this, put the module in learning mode (refer to
the module usage manuals, usually by pressing the key switch on the microprocessor for about 3 seconds until the signal LED flashes), then press
the button "Learning" on the motion detector (at least 3 seconds) until the signal LED on the micromodule to associate stops blinking.
Delete the association with micromodule
Place the module associated with the sensor previously in the learning mode (refer to the instruction manuals of the modules, usually by pressing
the key switch on the micromodule for about 3 seconds until the signal LED flashes), then press the button Of "Learning" on the motion detector
(at least 3 seconds) until the signal LED on the associated micromodule stops blinking.
Learning with smart WiFi socket cod.68.0010.50/I
After installing the bulb holder at the power grid, this can also be learned from the smart
WiFi plug socket. 68.0010.50 / I; To do so, access the smart app On Checking the Grip, press
"Add Device", select from the "Device Type -> Sensor" list, enter a name and press "Save".
Learning the saved device: Press the LEARN key
USER MANUAL – PIR WIRELESS SENSOR

Select Learning; "IV-1", "IV-2" and "IV-3" are not used.

With the lower sliding switch you can adjust how long the load shall be switched on when the motion detector
is triggered. You can set a time period of 5 minutes, 1 minute, 15 seconds and 6 seconds.

With the right sliding switch "H....L" you can set four levels and thus the brightness at which the motion detector
will be activated. Move the switch in direction "H": Motion detector will also be activated during the day. Move
the switch in direction "L": The motion detector is only active at night
COD. 68.0010.69/I