Siemens SN45ZS55CS Information For Use page 51

Fault
Coloured deposits (yellow,
orange, brown) that are easy
to remove are present inside
the appliance (mainly at the
bottom).
Plastic parts inside the appli-
ance are discoloured.
Plastic parts are discol-
oured.
Removable streaks are
present on glasses, glass-
ware with a metallic appear-
ance and cutlery.
Cause
The formation of films is due
to ingredients of food rem-
nants and tap water (limes-
cale) "soaplike".
Plastic parts inside the appli-
ance may become discol-
oured during the life of the
dishwasher.
Washing temperature is too
low.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
Amount of rinse aid to be
dispensed is set too high.
No rinse aid has been ad-
ded.
Detergent residue is present
in the final rinse. Lid of the
detergent dispenser is
blocked by tableware items
and will not open fully.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
Troubleshooting en
Troubleshooting
Check the setting of the water
1.
softening system.
Add special salt.
2.
→ "Adding special salt", Page 26
If you are using combined deter-
3.
gents (tabs), activate the water
softening system.
Follow the information about deter-
gents.
→ "Information on detergents",
Page 30
Discolouration can come about and
▶
will not impair functioning of the ap-
pliance.
Select a programme with a higher
▶
washing temperature.
→ "Programmes", Page 18
Only remove large remnants of food
▶
and do not prerinse tableware.
Set the rinse aid system to a lower
▶
setting.
→ "Adding rinse aid", Page 28
▶
Arrange tableware in the top basket
1.
tableware so the tab collecting tray
is not obstructed by tableware.
→ "Arrange tableware", Page 32
Items of tableware are blocking the
dispenser lid.
Do not place tableware or fra-
2.
grance dispensers in the tablet col-
lecting tray.
Only remove large remnants of food
▶
and do not prerinse tableware.
51