Summary of Contents for Cambridge Research Systems BOLDscreen 32 AVI
- Page 1 BOLDscreen 32 AVI Getting Started Version R01 April 2019 Cambridge Research Systems Ltd 80 Riverside Estate Sir Thomas Longley Road Rochester Kent ME2 4BH United Kingdom www.crsltd.com...
-
Page 2: Table Of Contents
BOLDscreen 32 AVI : Getting Started Contents Introduction ..................................3 System Features ................................3 Parts List ..................................4 Hardware Requirements ............................4 Connectors and controls ............................5 Rear panel ..................................5 Installation ..................................6 Operation ..................................... 6 Power states and button functions summary ..................... 7 Safety Warnings ................................ -
Page 3: Introduction
BOLDscreen 32 AVI : Getting Started Introduction BOLDscreen32 AVI makes it easy for you to connect multiple stimulus computers or other video sources to your BOLDscreen 32 MRI-compatible LCD display. The AVI allows switching easily between different input sources and provides an auxiliary output to drive a second monitor so that you can monitor the image shown to the patient from the control room. -
Page 4: Parts List
BOLDscreen 32 AVI : Getting Started Parts List BOLDscreen32 AVI — Video input switching box. Getting Started Guide — Printed version of this document. SD Card — If you purchased your AVI to work with your existing BOLDscreen32, you will have received a replacement San Disk 4 GB or 8GB SD/SDHC card or similar. -
Page 5: Connectors And Controls
BOLDscreen 32 AVI : Getting Started Connectors and controls Front panel Input selection buttons/indicators Video input ports Rear panel... -
Page 6: Installation
BOLDscreen 32 AVI : Getting Started Installation 1. You may have received a new SD card for use with your existing BOLDscreen 32. This contains a firmware upgrade and new set of FPGA logic files to support the AVI. Your monitor must be used with the new SD card –... -
Page 7: Power States And Button Functions Summary
BOLDscreen 32 AVI : Getting Started 32 through a head-coil mirror. The image on the clone monitor (HDMI output) will not be affected. 7) If required, switch between inputs by pressing the appropriate input select button. Again, there may be a delay while the BOLDscreen switches modes. -
Page 8: Safety Warnings
32 AVI unit and mains PSU contain no user serviceable components, refer all servicing to Cambridge Research Systems. Cleaning Clean external components of BOLDscreen 32 AVI with a damp cloth only. Do NOT allow fluids to enter the AVI unit or PSU. Do not sterilise in an autoclave. Mains PSU... - Page 9 BOLDscreen 32 AVI : Getting Started The mains PSU contains SIGNIFICANT FERRO-MAGNETIC CONTENT. DO NOT TAKE THE MAINS PSU INTO THE MAGNET ROOM. The power supply contains dangerous mains voltage and also has no user serviceable parts. Do not attempt to dismantle.
-
Page 10: Contact
BOLDscreen 32 AVI : Getting Started Contact Cambridge Research Systems Ltd Telephone: +44 1634 720707 Website: www.crsltd.com 80 Riverside, Sir Thomas Longley Road Rochester Kent ME2 4BH United Kingdom...