Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for GAPOSA SileoXS XSDC30
Summary of Contents for GAPOSA SileoXS XSDC30
- Page 1 ULTRA QUIET MOTORIZATION XSDC30...
- Page 2 CAREFULLY FOLLOW THESE INSTRUCTIONS. IT IS VERY IMPORTANT FOR THE SAFETY OF THE OPERATOR AND ALL OTHER CHILDREN OR BYSTANDERS. SAVE THESE INSTRUC- TIONS. IT IS IMPORTANT TO: • Check the blind in motion and keep children and bystanders far from it while in action. • Frequently check if any loss of balance, signs of wear or damaged wires are shown. • Do not use if any repairing or maintenance is needed. • In case of installation in awnings keep a distance of at least 1.5 ft from it (completely open) and whatever fixed item nearby. • The device is not intended to be used by anyone (including children) whose physical, sensory or mental capabili- ties are reduced, or lacking experience or knowledge, unless they have been granted through the intermediary of a person responsible for their safety, supervision or instruction concerning the use of the device. • Children should be supervised to ensure they do not play with the device and/or with fix control devices.
-
Page 3: Installation
1. INSTALLATION Ø > 25mm Check that the inner diameter of the tube is Insert the adaptors that will fit the roller tube: insert the crown (A) and the motor drive wheel (B) greater than 25mm. on the motor. WARNING: for some of the smaller tubes, you need to remove the stock bushing to install the appropriate crown (A). -
Page 4: Wiring - Power Supply
IT IS NOT SHIPPED FULLY CHARGED Battery comes 30 percent charged CAUTION from the factory. Use power charger (recom- mended by Gaposa) to charge the integrated - Ensure cable is kept clear of fabric Li-Ion battery. - Ensure antenna is kept straight and away from metal objects 1. -
Page 5: Sleep Mode
4 XSDC3EX030W Power operated motor 12VCC WARNING: The internal regulator works up to 15VCC Power cable Antenna Black wire right wire Positive + 3. SLEEP MODE (only for Li-Ion integrated battery motor) Sleep mode is a status which prevents a motor from moving during shipping or assembling: Wake up the motor: click the push button on the head of the motor the motor makes 1 jog Push- button... -
Page 6: Adding Transmitters
6. ADDING TRANSMITTERS Press and hold the PROG- Check the motor rotation Within 5 seconds, press the TX button on the back of then release the PROG-TX corresponding button (UP if the transmitter ALREADY PAIRED motor turns upwards or DOWN if button (the motor stops) the motor turns downwards) on until the motor starts moving... -
Page 7: Down Limit
9. SETTING THE LIMITS INDIVIDUALLY If the limits need to be changed after the initial limit setting procedure, it is possible to change the limit positions individually. One limit can be set without the other limit needing to be set. The motor can be in any postion to initiate the procedure. - Page 8 2. Within 8 seconds, using any Gaposa transmitter, press and hold both the PROG-TX and STOP buttons until the motor makes a long jog. Memory is now empty GAPOSA srl - via Ete, 90 - 63900 Fermo - Italy T. +39.0734.220701 - F. +39.0734.226389 - info@gaposa.com www.gaposa.com...