Tornador Classic Instructions For Use

SAFETY REQUIREMENTS

Wear appropriate hearing and eye
protection. Use in well ventilated area. Do
not exceed 90 psi. Do not use with acidic,
flammable or combustible products; "USE
ONLY WITH TORNADOR
®
Do not point cleaning tool at face or body.
KEEP OUT OF REACH OF CHILDREN.

AIR REQUIREMENTS

The TORNADOR cleaning tool requires
®
a minimum air pressure of 75 to 90 psi,
constant, for optimum performance.
DO NOT EXCEED 90 psi.
NOTE: Constant air supply may vary
depending on compressor size and
capabilities. Always make sure tank
and air lines are free from oil and water
contamination.
INSTRUCTIONS FOR USE
Tornador® covered by one or more of the following: U.S. Patent Nos. 6,883,732; 8,480,011; 8,690,077; 9,475,071; 10,182,696; 10,189,034; 10,343,177; 10,562,078; 10,730,062;
Taiwanese Patent No. I617360; U.S. Design Pat. Appl. Nos. 29/756,918; 29/756,919; 29/756,920; 29/756,921; 20150000705; 20150375272; Taiwan Application No. 103135808.
PRODUCTS."
Cleaning Fabric
1. Remove large debris and vacuum area to be cleaned.
2. Turn liquid air valve to upright position to deliver cleaning solution.
3. Hold cleaning nozzle 1 to 3 inches from area to be cleaned. Fully depress trigger.
Begin with overlapping motion over area to be cleaned.
4. Next turn valve to down position using just air and dry the area.
Cleaning Dashboard and Hard Surfaces.
1. Recommended air pressure set at 75 psi
2. Turn liquid valve to straight up vertical position, using a overlapping motion, spray
area to be cleaned.
3. Allow cleaning liquid to remain on surface for 10 -15 seconds.
4. Follow with air only by turning valve to the horizontal down position. Begin drying
with overlapping motion followed with a soft dry towel.
Tornador® is a registered trademark of ECP Inc. ©2021
Page 1 CONTINUED ON BACK PAGE