Technical Parameters
Detection Range
Measured Gas
Working Voltage
Output Method
Response Time
Recovery Time
Working Temperature
Working Humidity
Preheat Time
Mounting Diagram
1.
Wall mount, hole diameter 4 mm, pitch 36 mm
2.
DIN 35mm rail mount
Notes
1.
Confirm the polarity and the voltage of the power supply before powering ON the sensor.
2.
The analog output of this module is non-linear. When connect to microcontroller, it should be connected to ADC interface of the microcontroller.
3.
The relationship between the resistance ratio and the concentration is a logarithmic relationship.
300 10000 PPM
LPG, Methane, Propane, Butane, Hydrogen
24 VDC ± 0.2 V
0 10 V (Non-linear)
≤1 sec
≤30 sec
-20~65 °C
<95% RH (Non condensing)
>30 mins
2