Myzone MZ-Switch Troubleshooting

Troubleshooting
your MZ Switch belt

BEFORE YOU BEGIN

Wrist/Arm
Strap your MZ Switch to your wrist or arm then press the pulse button until you hear a
beep and see the light flash green
Chest
Secure your MZ Switch around chest and allow at least
detect your heart rate the chest strap reads a few cycles of your heart rate before
activating to ensure accuracy
Do not press the power button It automatically activates when the EKG pads on your
strap pick up your heart rate if you do press the power button in EKG mode you will hear
it beep off and there will be a delay before it activates again
Always thoroughly dampen the strap sensors to speed up connection

CHOOSE THE BEST STRAP FOR YOUR

Wear the wristband for swimming and non gripping activities with repetitive movements
Wear the armband for a more accurate reading of non gripping activities and repetitive movements
Don't use the armband for swimming
Wear the chest strap for the most accurate reading for all types of exercises but not swimming

SNUG IS BEST

Make sure the strap is comfortably snug on your wrist arm or chest
On your wrist or arm you should not be able to see the green LED s against your skin but it should not
be so tight that it restricts blood flow
On your chest it should be tight enough that it does not shift with movement but not to the point of
discomfort

CHECK YOUR BATTERY LEVEL

Check your battery at any time on the workout screen on the app No need to have your belt
activated the app remembers the charge level from the last time it saw your belt You will also receive a
pop up notification in the app when it dips below
this feature
If you wear your Switch on your arm or wrist and see it flash orange when you press it on or off this means
you are at % battery life Snap it into its charging cable and plug in to a computer USB or v charging
block to get fully charged up for next time and avoid data loss The blinking red light means it is charging It
will be steady green at
% please enable notifications for Myzone to access
%
seconds for your MZ Switch to