Commercial Electric LVSL-05CB-04 Use And Care Manual

Item #1005794342 /
1005794343 / 1005794341
Model #LVSL-05CB-04 /
LVSL-10CB-04 /LVSL-14CB-04
USE AND CARE GUIDE
LED CCT/BEAM ANGLE ADJUSTABLE SPOT LIGHT
THANK YOU
We appreciate the trust and confidence you have placed in Commercial Electric through the
purchase of this spot light. We strive to continually create quality products designed to
enhance your home. Visit us online to see our full line of products available for your home
improvement needs. Thank you for choosing Commercial Electric!
Pre-Installation
PACKAGE CONTENTS
A 7
1
2
6
3
5
4
Installation
1
Attaching and installling the Light
Never push the fixture into the ground by the lamp body (A) or use a
WARNING:
hammer to insert the ground stake (B) into the ground.
Insert the connector wire (3) into the groove located on the top of
□
the ground stake (7). Screw the spot light body (A) onto the top of
the ground stake (B).
Prepare a hole in the installation location. Use a tool such as a
□
screwdriver to prepare the installation hole to ensure that the
hole is not larger than the ground stake (B).
Install the fixture in the ground by pushing on the foot step (7) on
□
the ground stake (B). Do not push the lamp body (A).
Aim the light and loosen the wing nut (6). Rotate the light head to
□
the desired direction and tighten the wingnut (6) to secure the
position.
3
2
Connecting the wires
The wire connector (4 & 5) contacts have sharp edges for piercing the
Warning:
main low voltage cable. To avoid injury, do not touch the metal contacts.
The wire from low voltage power unit should be 12-16AWG type
CAUTION:
underground low energy circuit cable.
IMPORTANT:
 Protect the wiring by routing it in close proximity to the light fitting, or
next to a building structure such as a house or a deck.
 The landscape wire and connector can also be hidden under stone or
buried under grass at a maximum depth of 6 in. (15.24cm).
8
 Do not install the fixture within 10 ft. of a pool, spa,or fountain.
 Do not submerge the fixture in water.
□ Unlock the connector (4 & 5) by pushing
in from both sides and lift.
□ Align and fit the low voltage landscape
B
wire (not included) from the transformer
(not included) horizontally into the center
slot of the wire connector for landscape
wire (5).
□ Push down the wire to make sure the
wire is secure in the slot and laid flat as
shown in the picture below.
□ Press the wire connectors (4 & 5) back
together until they lock and there is no
gap between the two connectors (4 & 5).
□ Once the connectors are in place, it is
recommended to wrap them with electric
tape (not included).
□ After the fixture is installed, turn on the
transformer.
3
Adjusting the color temperature of the light
□ Choose your favorite correlated color temperature(CCT) from the
three options: 2700K warm white, 3000K soft white and 4000K
bright white.
□ Push the CCT button (2) to switch between no light, warm white,
soft white and bright white to make your selection.
NOTE: The factory setting for the correlated color
temperature (CCT) is 3000K warmest white.
4
Adjusting the beam angle
Choose your preferred beam angle: from min 30° - max 60°
□
Rotate the beam angle control knob (1) clockwise or counter
□
clockwise to adjust to your desired beam angle.
Troubleshooting
5
4
Care ant Cleaning
5
□
Clean the fixture with a soft dry cloth.
□
Do not use any cleaners with chemicals, solvents or harsh abrasives.
Warranty
WHAT IS COVERED
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of five (5) years from date of purchase. This warranty applies only
to the original consumer and only to products used in normal use and service. If this product
is found to be defective, the manufacturer's only obligation, and your exclusive remedy, is the
repair or replacement of the product at the manufacturer's discretion, provided that the
product has not been damaged through misuse, abuse, accident, modifications, alterations,
neglect or mishandling.
WHAT IS NOT COVERED
This warranty shall not apply to any product that is found to have been improperly installed,
set-up, or used in any way not in accordance with the instructions supplied with the product.
This warranty shall not apply to a failure of the product as a result of an accident, misuse,
abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty
material or workmanship. This warranty shall not apply to the finish on any portion of the
product, such as surface and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specifically disclaims any warranty, whether express
or implied, of fitness for a particular purpose, other than the warranty contained herein. The
manufacturer specifically disclaims any liability and shall not be liable for any consequential
or incidental loss or damage, including but not limited to any labor / expense costs involved in
the replacement or repair of said product.
Contact the Customer Service Team at 1-877-572-0313 or visit www.HOMEDEPOT.com.
Questions, problems, missing parts? Before returning to the store,
call CE Tech Customer Service
8 a.m.- 7 p.m., EST, Monday-Friday, 9 a.m. - 6 p.m., EST, Saturday
1-877-527-0313
HOMEDEPOT.COM