Advertisement
Table of Contents
www.surebasics.com
Installation
1. Before removing the tape backing cover, test for clearance by placing the lock at
the desired overlapping of doors location to make sure it is not interfering with the
opening of the sliding door or window gap (minimum 7mm gap required).
2. Once position has been determined and tested, clean and dry the surface area.
3. Peel tape backing off, attach as high as possible and close to the place where the
doors overlap. Press down firmly for a few seconds. Leave on for 24 hours for maxi-
mum adhesion before first use.
Check out installation video: surebasics.com/sliding
Advertisement
Table of Contents
Related Manuals for sure basics SB22
Summary of Contents for sure basics SB22
- Page 1 www.surebasics.com Installation 1. Before removing the tape backing cover, test for clearance by placing the lock at the desired overlapping of doors location to make sure it is not interfering with the opening of the sliding door or window gap (minimum 7mm gap required). 2.
- Page 2 www.surebasics.com To Use 1. Simply lift Part A upwards with your finger to the lock position to secure the open- ing of the sliding door or window (fig 1). 2. To unlock, slightly pull part B upwards with your thumb and finger to release and then press down (fig 2).
Need help?
Do you have a question about the SB22 and is the answer not in the manual?
Questions and answers