TWC Zipscreen Programming Instructions

initial pairing

- Remove end cap off solar
panel (right hand end).
- Select a channel on
remote.
- Hold programming button
on solar panel for
approximately 5 seconds
until a clicking sound is
heard and LED light will
light up once.
- Hold stop button down on
remote until motor jogs
confirming successful
pairing (LED light will flash
on solar panel 3 times).
setting bottom limit left
hand control side
- Press the down button on
remote and stop blind before it
reaches the bottom of the
opening.
- Insert the wand supplied into
the white setting hole.
- Turn the wand in an anti-
clockwise direction and the blind
will lower with each rotation.
- Continue to turn the wand until
the desired bottom limit is
reached.
- If the blind needs to be raised
to adjust the bottom limit, rotate
the wand clockwise to adjust.
- Once the bottom limit is
reached press and hold the stop
button to lock this position
(approx. 5 seconds).
outdoor motor
programming
instructions

check blind direction

- Press up button to confirm
blind will travel in the up
- If blind is travelling in the wrong
direction, hold up & down
buttons at the same time until
- Check direction of blind to
make sure this is now travelling
in the correct direction.
wirefree
direction.
motor jogs.