About this guide We’re here to help you get the most from your stand mixer, so please keep hold of this manual for future use. WARNINGS: THIS PRODUCT WAS DESIGNED AND MANUFACTURED TO MEET STRICT QUALITY AND SAFETY STANDARDS. THERE ARE, HOWEVER, SOME OPERATIONAL PRECAUTIONS YOU SHOULD BE AWARE OF.
Page 4
external timer or separate remote-control system. Don’t use the stand mixer for anything other than its intended use. 14. Please don’t dismantle. If a fault occurs have the stand mixer 15. Do not continuously operate for more than 7 minutes, at any speed setting, at a time as this can overheat the motor.
Page 5
You should have Mixer, bowl, whisk, beater, splashguard & dough hook How to… …recognise the parts of your stand mixer Accessory connector Tilt release button Speed adjuster dial plashguard (4.0L) Bowl Whisk Beater Dough hook...
Page 6
How to… …assemble/disassemble the attachments on your stand mixer Please note When assembling ensure the mixer isn’t plugged into the mains and the speed adjuster dial is set to ‘0’. Before using for the first time, we recommend you wash the bowl and attachments in warm, soapy water and dry thoroughly.
Page 7
Place whisk, beater or dough hook into the accessory connector. Push up and rotate as far as it will turn, and then release the accessory so it locks over the pin on the connector. To remove the accessory, push up and turn the opposite way to unlock.
Page 8
How to… …use your stand mixer 1. Plug the mixer into the power socket and switch on. Ensure the speed adjuster dial is set to ‘0’. Ensure the stand mixer is on a flat, stable surface and away from the edge. The suction feet should help stick the stand to the surface.
Page 9
6. Turn off at the mains socket and unplug. Press the tilt release button and lift the stand mixer head. To remove the attachment, push the attachment up and turn clockwise to release it. As a guide for mixing using the attachments, please refer to the table below. Name Purpose •...
Page 10
How to… …clean your stand mixer Make sure the stand mixer is switched off and disconnected from the power. 1. Wipe over the outside surfaces with a damp cloth and wipe any excess food particles from the power cord (never immerse the mixer or power cord in water or liquid). 2.
Page 12
Produced for ASDA, Leeds LS11 5AD/ASDA, telephone number or address shown Antrim BT41 4GY. opposite. N.B. When calling or writing please have your product site GSM101B-20 George Home Product name: stand mixer code handy. 15A.10.21.161 Product site code:...
Need help?
Do you have a question about the GSM101B-20 and is the answer not in the manual?
Questions and answers