Advertisement
Assembly:
The CL68RGB comes fully assembled, including the barn doors. If you prefer to remove the barn
doors, simply take out the 4 Barn Door Attachment Bolts (6). They can be removed or reinstalled
anytime you like.
Mounting the Light:
Slide the base of the Light Stand Mount (1) onto the top of a sturdy light stand that has a 5/8"
mounting stud. Be sure the Light Stand Connection Knob (3) is loosened and the cavity in the base of
the Light Stand Mount (1) is clear before placing it onto a light stand. Now tighten the Light Stand
Connection Knob (3).
Once mounted, use the Tilt Control Knobs (4) to change the light's angle. While holding the light,
loosen these knobs, tilt the light, and then re-tighten the knobs. The Yoke (2) will remain in place
while the body of the light tilts within it.
Powering the Light:
Be sure the light is switched OFF before attempting to connect it to any power source and also before
disconnecting the light from any power source. Do this by setting the Power Switch (10) to its center
position.
Connecting to AC Power
An AC cord is included with this kit. This is, in fact, a two-part cord with a transformer. Locate both
parts and connect them together using the figure-8 style connector in the transformer. Next, connect
the barrel-style end of the cord to the light's Power Input Socket (17). Finally, connect the other end of
the AC cord to a common wall outlet with a voltage supply of 100 – 240 V.
When connecting the AC cord, be sure to support the transformer at all times. A stretchy,
hook-and-loop strap is included to aid with this. Use the strap to attach the transformer to your light
stand by wrapping it around them both, leaving some slack in the cord that goes from the transformer
to the back of the light. Never allow the transformer to hang or put a strain on the cord or the Power
Input Socket (17).
Once you have securely connected the CL68RGB to a proper wall outlet power source, push the
Power Switch (10) to the right to turn the light ON.
(2)
Advertisement
