Training; Preparation; Operation - Toro LT3240 Instruction Manual & Parts List

SAFETY PRECAUTIONS
THESE INSTRUCTIONS ARE IN ADDITION TO THOSE CONTAINED IN THE MACHINE
OPERATORS MANUAL UNLESS OTHERWISE STATED. READ AND UNDERSTAND THE
SEPARATE MACHINE OPERATORS MANUAL BEFORE ATTEMPTING TO FIT THIS KIT.
THE FOLLOWING PRECAUTIONS MUST BE TAKEN TO HELP PREVENT ACCIDENTS.
SAFETY PRECAUTIONS - TRAINING
Read the instructions carefully. Be familiar with the use of the equipment.
Ensure that the specified torque settings are adhered to.
The cab and its mountings must not be drilled, cut or altered in any way.
All drivers should seek and obtain professional and practical instruction. Such instruction should emphasise the need
for care and concentration when working with this equipment.
SAFETY PRECAUTIONS - PREPARATION
Ensure that all lifting equipment is in good condition and has sufficient capacity to lift the item required as specified in
this manual.
Always ask for assistance when lifting heavy or awkward loads.
Ensure that the seat belt is correctly fitted and in good condition. Always replace a damaged seat belt.
SAFETY PRECAUTIONS - OPERATION
Always wear the seat belt when the safety cab is fitted.
Care should be taken when using the mower on any slope where ground conditions are such that there may be a risk
of the mower rolling over. The requirements of SI 1998 No. 2306 "Provisions and Use of Work Equipment
Regulations" should be considered.
WARNING: ALWAYS SEEK PROFESSIONAL ADVICE FROM YOUR LOCAL AUTHORISED DEALER IF,
AFTER STUDYING THIS, YOU ARE UNSURE HOW TO FIT THIS KIT.
Care should be taken when using the mower on any slope where ground conditions are such that there may be a risk
of the mower rolling over. The requirements of 89/355/EEC, as amended by 95/63/EEC 'Provision and Use of Work
Equipment Directive' should be considered.
Stability angles given are maximum figures and are for guidance only. Particular conditions such as wet grass or
uneven ground may not permit safe operation on the slope limit stated.
Issued: 01.04.11 Approved: Mod. No.
5060358
Sheet 5 of 64 Part No. 111-4431 (A)