Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Lippert Jack-IT SpaceOpt
Summary of Contents for Lippert Jack-IT SpaceOpt
- Page 1 Jack-IT SpaceOpt ® OEM INSTALLATION MANUAL...
- Page 2 Lippert limited warranty. The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause death or serious personal injury if not performed safely and within the parameters set forth in this manual.
- Page 3 Installation The trailer MUST be supported per manufacturer's recommendations before working underneath. Failure to do so may result in death, serious personal injury or severe product or property damage. Remove the tongue jack from the coupler. Position the PowerTower™ (Fig. 1G) on the coupler. Place the tongue jack on the PowerTower (Fig.
- Page 4 Note: Several hole positions are provided for cradles (Fig. 4A). Pads (Fig. 4D) and SwayStop™ pins (Fig. 4F) slide along the length of the wings (Fig. 4G). Slide one SwayStop pin (Fig. 4F) onto each wing (Fig. 4G) from the bottom so that the SwayStop locates between the snap pin (Fig.
- Page 5 Manual Tongue Jack Operation Remove the Stinger (Fig. 6A) from the PowerTower (Fig. 6B). Remove the rubber plug located on top of the tongue jack (Fig. 7A) to expose the manual drive shaft. (PowerTower removed for clarity.) Utilize the opening in the top of the PowerTower (Fig. 8A) to insert the appropriately-sized ratchet, extension and socket or the tongue jack crank handle to turn the drive shaft and manually raise or lower the jack.
- Page 6 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (LCI). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the Jack-IT SpaceOpt and is the answer not in the manual?
Questions and answers