Advertisement
Table of Contents
Advertisement
Table of Contents
Summary of Contents for Neurio Murata 1DX
- Page 1 Murata 1DX Integration Guide Neurio Technology ULC 2022-12-02...
- Page 2 Murata 1DX Integration Guide FCC ID of this product is as follows. • FCC ID: W72-1DX For Neurio Technology ULC integration use in host product(s) only. Device cannot be sold to general public. Contents Voltage Antenna Notice...
- Page 3 1. Supply Voltage Min. Typ. Max. Unit Specification Temperature Range Deg C Specification VBAT Voltage VDDIO 1.71 1.8 or 3.3 3.63...
- Page 4 2. Antenna Please perform antenna design that follows the specifications of the antenna The concrete contents of a check are the following three points. １）It is the same type as the antenna type of antenna specifications. • Confirm the same size as the Gerber file. ２）An antenna gain is lower than a gain given in antenna specifications.
- Page 5 3. Notice For Neurio Technology ULC integration use in host product(s) only. Device cannot be sold to general public. The following statements are required by FCC/IC to be included on the product and in the Installation manual. Contains Transmitter Module FCC ID: W72-1DX Contains FCC ID: W72-1DX •...
- Page 6 3. Notice • When installing it in a mobile equipment. Please describe the following warning to the manual. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body.
- Page 7 3. Notice This device is intended only for Neurio Technology integration use under the following conditions: 1)The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2)The transmitter module may not be co-located with any other transmitter or antenna.
- Page 8 3. Notice End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID:XXXXXXXXXX”.
Need help?
Do you have a question about the Murata 1DX and is the answer not in the manual?
Questions and answers