Table of Contents
Advertisement
Quick Links
EN
Left / -
Key holder
2
Settings
2.1 Setting procedure
Confirm
increase/decrease the values
You can leave the settings menu at any time and return to
the main menu by pressing the
3
Use
3.1 Positioning the product
3.2 Viewing the information
Number of steps Distance travelled
3.3 Starting the measurement
Your pedometer starts to measure automatically when you
start walking.
4
Changing the battery
ONwalk 100
Screen
Right / +
Confirm /
Reset
to zero
button for 1.5 seconds.
1,5 sec.
KM
Settings
1
First set-up
1.1. Switching on
1,5 sec.
1.2 Setting your height
Setting your height enables automatic calculation of your length
of stride. The length of stride can also be set manually in the
settings menu.
2.2 Setting your stride length
By default, your stride length is calculated according to your
height. If you wish to customise your stride length, please go
to „Manu" mode
To find out your stride length, walk 10 metres while counting
the number of steps then do this calculation: stride length = 10
metres / number of steps.
3.4. Resetting to zero
3.5 Automatic standby
A
B
1/2
M
2 sec.
M
1,5 sec.
30 sec.
Advertisement
Table of Contents
Related Manuals for GEONAUTE ONwalk 100
Summary of Contents for GEONAUTE ONwalk 100
- Page 1 ONwalk 100 First set-up 1.1. Switching on Screen 1,5 sec. 2 sec. Right / + Left / - 1.2 Setting your height Confirm / Reset Key holder to zero Setting your height enables automatic calculation of your length of stride. The length of stride can also be set manually in the settings menu.
- Page 2 The algorithms used to calculate the different values displayed by your pedometer have been developed for walking and brisk walking only. The accuracy of these values will be severely reduced if used when running. Therefore, we do not recommend using this product for running.
Need help?
Do you have a question about the ONwalk 100 and is the answer not in the manual?
Questions and answers