Summary of Contents for HJM C8
- Page 1 Model C8 Portable Conductivity/TDS Meter (Versions 353) Micro-processor controlled, auto-ranging from 1-10’000 μS/cm (1-7000TDS).
- Page 2 “Low Bat” Message if voltage drops to below 8 Volts. GENERAL INFORMATION. The C8 meter is factory calibrated with a 1413 µ S/cm solution and does not need calibration during normal operation. Incorrect readings will result if the electrodes are dirty. This is mostly noticeable on conductivity above 2000 μS/cm.
- Page 3 4) Empty the cup and refill with new test solution. 5) Press the “Push to read” switch for 2 seconds. 6) If the reading is incorrect press the “Set” button on the back of the C8 meter for 5 seconds. This will enable the calibration function.
- Page 4 C8 HJM2523/353...
Need help?
Do you have a question about the C8 and is the answer not in the manual?
Questions and answers