Universal Furniture Explore Home MIDTOWN 805260/26FR Instruction Sheet

805260/26FR
805250/25FR
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
A Headboard
C Side Rail
E
Slat Panel
G
Headboard legs
Assembly Procedure
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Unzipping from the back of headboard ,install wings(B) to the headboard(A) with bolt
(7),spring washer (8)and flat washer (9).Tighten them by wrench (10).
Step 3:Attach the headboard legs(G) with the bolt (11) and spring washer (8) to the holes on the
bottom of headboard(A) . Screw footboard legs(H) into holes on the bottom of footboard (D)..
Step 4:Assemble side rails(C) with headboard(A) and footboard(D) using bolts (1), curved
washers(2) , spring washers(3) and nuts(4). Tighten them by wrench (6).
Step 5: Screw center supports (6) into slat panels (E).Put slat panels(E) onto the inside notches of
side rails(C) , tighten them with screws(5) by screwdriver (not provided).
Note: 805250/25FR bed has 3pcs center support.
Assembly is now complete.
INSTRUCTION SHEET
Qty. #
1 pc B
2pcs D
F
3pcs
H
2pcs
: (Please follow the sketches below.)
Description
Wings
Footboard
Center support
Footboard legs
MIDTOWN BED
Qty.
2 pcs
1pcs
6pcs
2pcs