allgood 9943N5 Quick Start Manual

Fixing Template for: 9943N5&N6, 9944N5&N6,
9945N5L&R, 9945N6L&R, 9946N5L&R, 9946N6L&R
(suffix 'F' included to above denotes radiused forend)
FT9943N
Issue 01‐08/20
Reversing the latchbolt
Trigger
32
Recess for
radiused forends
T: 020 7387 9951 1 www.allgood.co.uk
IMPORTANT NOTES:
To ensure lock functions correctly and that the warranty conditions are met:
• The lock must be supported at the back of the case, the spindle must be
square to the face of door and installed in accordance with the fitting instructions.
• Bolts should be checked frequently for easy action, and if required, lubricated
with light oil.
• Some lock functions require certain holes to be cut one side only, check before cutting.
22 19
28
4
72
20
A
PILOT HOLES ONLY
FOR No.6 SCREWS
105
114
Door Gap: maintain nominal 3mm gap
between door and frame
Wiring diagram WD9943N
19
supplied with the lock
2
38 CRS
17
16
10
Suitable for timber fire doors 30, 60 Min. and
metal fire doors upto 240 Min.
Timber door installation:
2812 ‐ CPR ‐ ABB035
When installing this product to an EN 1634
3
EN 179:2008
compliant timber fire door, intumescent pack ref:
9945N5L&R, 9945N6L&R, 9946N5L&R, 9946N6L&R
XX9943NFP for 30 & 60 Min. rating must be used.
(suffix 'F' included to above denotes radiused forend)
(see over page for instructions)
Important
Before fitting the lock, carefully read the instructions below:
Instructions:
1. Before cutting the door, check whether lever & cylinder holes are required
on one or both sides of the door.
2. Reversing the latchbolt
a. Remove the retaining screw 'A' from the latchbolt assembly.
b. Pull the latchbolt free.
c. Turn the latchbolt around and twist it back into place in the lockcase,
ensuring that the trigger is hooked behind the forend. (see drg. top left)
d. Replace retaining screw 'A' ensuring it is fully tightenerd.
3. When using half set of lever, use XX9052NT spindle (supplied C/W Fix. Inst.)
4. Lever rose Assy. must be fitted back to back together using screws provided.
Note: Screws supplied with Lever Furn. should be fitted through the vertical slots of
the lock case, and additionally No. 6 self tapping screws supplied with lock case fitted
horizontal. (see Fig. A overleaf)
Dimensions shown are guidance only, and for preperation of door,
refer to actual lockcase to make allowances for cutting tolerances .
MAKE ALLOWANCES FOR WHEN FIRE PACK USED.
25*
32
* MORTAR GUARD
DIMENSIONS
Allgood plc, 63‐83 Brearley Street
Birmingham B19 3NT
15
7 6 B 1 3 4 2 A B/D
CF 623
3.0
17
MORTAR
GUARD
27
Recycle responsibly