Advertisement
Quick Links
Presentation
Netw'o is a range LoRaWAN tester. It presents simply by leds the quality of the uplink and downlink. It could be associated to a smartphone via BLE to control and monitor m
the information about the link budget.
Thank to this BLE feature the Netw'o can be remotely managed to be in real condition of an installation of device ( close door, high position,...). The result of the test with th
point, in json or csv, can be shared directly through the smartphone (email, social network,...).
The Netw'o can be set on different LoRaWAN server through different devEUI, and easily it is possible to swicth from one network to another.
Declaration of conformity
User guide
Set the devEUI appEUI on the network on which you want to test the RF range. The main devEUI is on the label:
The others devEUI use the same appEUI and Keys; devEUIs are derivated from the main:
70B3D5E75E1xxxxx
70B3D5E75E2xxxxx
Start the device by pressing the button during 1s. Device rings until associating to the network.
5 link budget frames are sent just after association with 15 seconds of delay between.
After transmitting, there is 2 indicators: the first one is the quality of the Transmission, the second one is the quality of reception.
Transmission:
Red:
The signal transmitted by the device is VERY BAD receipt by the gateways. Risk of loss a lot of uplink. Try to put the device higher or in other place.
Orange: The signal transmitted by the device is BAD receipt by the gateways.
Green: The signal transmitted by the device is GOOD receipt by the gateways.
GreenGreen: The signal transmitted by the device is VERY GOOD receipt by the gateways.
Reception:
Red:
The signal received by the device is VERY BAD. Risk of loss a lot of downlink. Try to put the device higher or in other place.
Orange: The signal received by the device is BAD.
Green: The signal received by the device is GOOD.
GreenGreen: The signal received by the device is VERY GOOD.
NETW'O
Advertisement
Summary of Contents for WATTECO NETW'O
- Page 1 Thank to this BLE feature the Netw'o can be remotely managed to be in real condition of an installation of device ( close door, high position,...). The result of the test with th point, in json or csv, can be shared directly through the smartphone (email, social network,...).
- Page 2 Once the Netw'o device switched ON, do a scan on the application: The Netw'o device appears on the application, click on it to work with (the BLE name is based on the 8 last DevEUI digits): After each reception the following window is refreshed:...
- Page 3 RX graph: SNR, RSSI and SF of the Downlink TX graph: Margin, SF of the Uplink, Number of Gateways...
- Page 4 Click On Test Radio to launch a new burst of Uplink with the selected argument:...
- Page 5 To change the LoRaWAN server, you can select another devEUI. Directly the Netw'o try to associate to the new LoRaWAN server on which the selected devEUI is configur Click on "...", then select "Send the report" to share a csv or json file with all datas embedding location, timestamp, rssi, snr,...
- Page 6 [EN] The use of the Netw'o application for iOS and Android does not generate any collection of personal data. Watteco will not require you to create an accou data from our application will be transmitted to us.