KEXIN KX-5188A160 Quick Start Manual

Hide thumbs

科信高频超音频感应加热设备

Dear users:

Thank you for choosing KEXIN induction heating equipment, induction heating

equipment KEXIN end selection of imported components, using the most advanced

technology coupled with excellent craft production made. Continuous innovation in recent

years was finally complete a number of high-end models, with high efficiency and good

working conditions, heating quickly, easy to operate and so on. Compared with other similar

products energy-saving 10% -40%, and compared with the old IF-saving more than 50% so

that in the same industry that have a high level.

In the installation of this device, please read this manual, and operational staff rigorous

training in order to make better use of the product.

In case there are any questions, please contact our factory technicians or after-sales

service hot line so that we can better serve you.

电话：0577-27872900

传真：0577-27872911

Table of Contents

Need help?

Do you have a question about the KX-5188A160 and is the answer not in the manual?

Questions and answers

Summary of Contents for KEXIN KX-5188A160

Page 1 Dear users: Thank you for choosing KEXIN induction heating equipment, induction heating equipment KEXIN end selection of imported components, using the most advanced technology coupled with excellent craft production made. Continuous innovation in recent years was finally complete a number of high-end models, with high efficiency and good working conditions, heating quickly, easy to operate and so on.
Page 2 Table 1: Model Power Power cables ≥50mm KX-5188A160 160KW Distribution power capacity, cable diameter, and external air switching capacity Single-core multi-strand copper cable, if use with aluminum cable, the diameter should be doubled. Section Letter induction heating equipment, detailed parameter table...
Page 3 科信高频超音频感应加热设备 material, if necessary, to install with filter. 3. Water temperature should be controlled between 5-35 ° C. 4. In order to avoid the foulings in equipment to block the cooling system, the best PH value of water is 7-8.5. 5.
Page 4 科信高频超音频感应加热设备 Operational procedures Panel functions and operating instructions DC voltage DC Current Oscillation current Small Power conditioning Power Start/Stop Overcurrent REMOTE Reset 1. DC Voltage Meter: When the device is connected with power source, this display shows the DC voltage inside the device.
Page 5 科信高频超音频感应加热设备 5. Heating / stop button: In standby mode, press this button and then equipment start to heating operation. Press the button again, equipment will stop to heat. 6. Overcurrent reset button: In working mode, due to a variety of causes which lead to over-current indicator light and with a continuous buzzing sound, the equipment will automatically stop working, it indicates that the equipment is under over-current protection.
Page 6 科信高频超音频感应加热设备 ○ 4. Press the start/stop button, and the working indicator light (green), put the heating part into the induction coil and adjust the power knob to the right position, when the workpiece temperature meets the requirements, then turn down the power knob, pick up the heated workpiece, and then place in a new workpiece, repeat the above procedure.
Page 7 科信高频超音频感应加热设备 d c b a Grounding Grounding output input input output water water-pump 电话：0577-27872900 传真：0577-27872911...