Bemo -TOP Assembly Manual

ASSEMBLY GUIDE
BEMO-TOP- AND BEMO-AKKORD RAIL
The BEMO-TOP- or BEMO-AKKORD rail is the most economical and safest solution for mounting photovoltaic and solar thermal
modules on BEMO standing seam. The rails contribute to permanent safety and to the avoidance of point loads and constraints.
In addition, the roof remains completely free of penetration and thus permanently tight and functional. Air-conditioning units or
elevated modules can also be mounted and fastened on the TOP and AKKORD rails. For information if the rail must be mounted on
each or every second seam, please refer to the structural analysis.
Step 1
The Top- or Akkord rail is attached to the ready-seamed BEMO-Standing seam.
1. Ready-seamed BEMO-Standing seam
Step 2
The hand seaming tool is placed on the profile and seamed with the BEMO standing seam profile by pressing the grip pieces apart.
This process is done over approximately the first 30 cm of the rails.
1. Setting up the hand folding tool
BEMO SYSTEMS GmbH
Max-Eyth-Straße 2
74532 Ilshofen-Eckartshausen
2. Attaching Akkord-rails (left) or Top-rails (right)
T: +49 7904 29899-60
E: sales@bemo.com
W: www.bemo.com
Seite 1 von 3
07/2021