Motorola iDEN i560 User Manual page 38

MOTOtalk TM
Making and Receiving Code Calls in
MOTOtalk
To make a code call in MOTOtalk:
1 Press and hold the PTT button. MT Transmit
appears on the first line of display. Begin
speaking after your phone emits the MOTOtalk
tone.
2 Release the PTT button to listen.
The tone emitted from your phone when using
MOTOtalk is 4 beeps and sounds different from the
standard tone heard with on-network Private and
group calls.
If you receive an error message:
• There may be no parties on your channel or
code.
• You are out of range.
When you receive a code call using MOTOtalk, MT
Receive appears on the first line of the display.
Note: An incoming MOTOtalk call can be
terminated at any time by pressing e.
28
Receive All
You can set your phone to receive MOTOtalk
transmissions from any phone that is set to the
same channel, regardless of the code (1-15), by
setting the code to Receive All. When you receive
transmissions with the code set to Receive All, the
display changes from Receive All to the code on
which the transmission was received.
Tip: You can reply to an incoming call within 6
seconds after hearing the short ending
beep by pressing the PTT button.
Note: You cannot initiate a code call when the
code is set to Receive All. If you press
the PTT button with the code set to
Receive All, you will receive an error
message.
To set the code to Receive All:
1 From the MOTOtalk idle screen, press A under
Edit.
2 Scroll to Code.
3 Press A under Edit.
4 Select Receive All.
5 When you are finished, press A under Back to
return to the MOTOtalk idle screen.