Motorola iDEN i30sx Replacement Instructions

Faceplates and keypads removal and replacement procedure

Hide thumbs Also See for iDEN i30sx:

i30sx Faceplates and Keypads

Your i30sx phone comes with a standard faceplate and keypad. You can order

additional face plates and keypads to change the look of your phone.

The following steps and accompanying illustration detail the procedure for

removing and replacing the changeable faceplate and keypad.

NOTE: Before replacing the faceplate, ensure that the keypad is

present and undamaged. For security and operational reasons,

power to the i30sx phone should be off prior to performing the

removal and replacement procedure. There is a protective

plastic liner over the lens. Peel off prior to operation.

While holding the back of the phone, press the

faceplate release button located at the bottom of

the phone to release the faceplate. When you

press the release button, ensure that both sides

are disengaged from the faceplate prior to

removal.

In an upward motion, grasp the bottom part of the faceplate and detach

it from the phone.

Remove the keypad from the phone (or from the faceplate).

Release Button

135

Table of Contents

Do you have a question about the iDEN i30sx and is the answer not in the manual?

Page 1 i30sx Faceplates and Keypads Your i30sx phone comes with a standard faceplate and keypad. You can order additional face plates and keypads to change the look of your phone. The following steps and accompanying illustration detail the procedure for removing and replacing the changeable faceplate and keypad. NOTE: Before replacing the faceplate, ensure that the keypad is present and undamaged.
Page 2 To replace the faceplate and keypad, lay the keypad on the phone body. As shown in the illustration, attach the faceplate to the phone body, first at the top and then at the bottom. The top of the faceplate needs to be securely seated into the top of the phone.