Advertisement
AeGIS Wiegand Radio Reader
Output Data: Data 0 and Data 1 standard Wiegand
electrical and protocol interface.
Operating Environment: -22°F to +155°F.
Mount: Inside the AeGIS 9000 Series or Outside.
INSTALLATION
Installation Manual
INTRODUCTION
Pach and Company thanks and conratulates you on the purchase of
your AeGIS Wiegand Radio Reader (AWRR) and transmitter (AWRT).
The AWRR is designed to interface with AeGIS 9000 Series. The
AWRR will be installed inside the AeGIS 9000 Series if order at the
same time at no extra cost for installtion. The antenna will be mounted
on top of the system.
SPECIFICATIONS
Power Input: 5.0 - 24 VDC Regulated (5 VDC is supplied by the
AeGIS 9000 Series).
Current Consumption: 30 mA operating.
Radio Frequency:
LO Reradiation: 200 microVolt/meter @ 3 meters (maximum)
Data Format: MegaCode
Sensitivity: -100dBm minimum
Desensitivity: 20 dB manual attenuation at the antenna input
Antenna: 9-1/2 in whip antenna with F-connector (supplied).
Bandwidth: 300 Khz
Image Rejection: 40 dB.
Enclosure Construction: Weather-resistant, anodized alu-
minum enclosure with removable end caps to provide wiring
and programming access; end caps secured with screws.
Shipping Weight: 3.0 Lbs. approximate.
Warranty:
318 Mhz
"Two Years
Warranty".
Figure 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for PACH & COMPANY AeGIS Wiegand
- Page 1 INTRODUCTION Pach and Company thanks and conratulates you on the purchase of your AeGIS Wiegand Radio Reader (AWRR) and transmitter (AWRT). The AWRR is designed to interface with AeGIS 9000 Series. The AWRR will be installed inside the AeGIS 9000 Series if order at the same time at no extra cost for installtion.
- Page 2 Step 1 Set JP1 to 5VDC if the AWRR is connected to the AeGIS 9000 Series (see fig. 1). If the AWRR purchased as a package with the AeGIS 9000 Series, the systems are prewired from the manufacturer. Step 2 Turn the power OFF on the AeGIS 9000 Series. Step 3 Connect the wires as shown on fig.1.
- Page 3 Step 3 It is not necessary to set the DIP SWITCH B and D. PROGRAM AND TEST THE SYSTEM Step 1 With power applied to the receiver, press and release the program button, see fig.1. Step 2 Test the transmitters from various locations to determine the radio range. Step 3 Adjust the receiver internal radio range knob to limit radio reception if required (clockwise to increase, counter clockwise to decrease) Step 4 Reception pattern will vary depending on antenna used and surrounding structures.
Need help?
Do you have a question about the AeGIS Wiegand and is the answer not in the manual?
Questions and answers