Sterling 4388 Assembly Instructions

Tetherball

Advertisement

FOR AGES 6 UP

RULES OF THE GAME:

1. With each player standing in each side of the playing zone, the server
hits the ball to go around the pole in any direction.
2. The ball may be hit with either an open or closed hand.
3. As the ball travels around the pole, the server attempts to hit it again
and again in the direction of the original serve to wind it around the
pole.
4. The opposing player will try to hit the ball back turning in the oppo-
site direction.
5. The rst player who winds the rope completely around the pole is
the winner.

TETHERBALL FOULS:

1. Hitting the ball with any part of the body.
2. Stopping the game by holding or catching the ball.
3. Touching the pole with any part of the body.
4. Hitting or catching the rope.
5. Playing the ball while standing outside of the playing zone.
NOTE: USE ON LEVEL SURFACE ONLY.
BEFORE EACH USE INSPECT UNIT TO MAKE SURE ALL CONNECTIONS,
POLE SECTIONS HARDWARE AND BALL ARE TIGHT AND SECURE.
USE THIS PRODUCT FOR THE INTENDED PURPOSE ONLY. SUNNYWOOD
INC ASSUMES NO LIABILITY FOR MISUSE OF THIS PRODUCT.
Distributed exclusively by:
Sunnywood Inc., Illinois, U.S.A.
www.sunnywood.net
Item No. 4388
© 2015 Sunnywood Inc. All rights reserved.
TETHERBALL
AND
PLAYING RULES
Ground Sleeve
8" Tetherball with
Snap Clip
Air Pump
Bottom Pole
Top Pole
Galvanized Poles

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4388 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sterling 4388

  • Page 1 8” Tetherball with Snap Clip INC ASSUMES NO LIABILITY FOR MISUSE OF THIS PRODUCT. Distributed exclusively by: Sunnywood Inc., Illinois, U.S.A. www.sunnywood.net Air Pump Bottom Pole Item No. 4388 Top Pole Galvanized Poles © 2015 Sunnywood Inc. All rights reserved.
  • Page 2 ASSEMBLY INSTRUCTIONS B. Pole Installation Adult Assembly and Supervision Required 1. Insert the Bottom Pole into the Ground Sleeve 2. Attach the Snap Clip with Tetherball to the Eyebolt at the A. Sleeve installation top of the Top Pole. 3. Insert the Top Pole onto the Bottom Pole until the button 1.

Table of Contents