3. Getting started & safety check ....................11 4. Behaviour in road traffic ......................13 Klever’s E-bike drive train 5. Klever’s proprietary propulsion – the BIACTRON-system ............14 5.1 Sensors & their function ....................... 16 5.2 Levels of electric motor support .................... 17 5.3 Regeneration of battery capacity ..................
Page 3
8. Storage & transport of your Klever E-bike ................54 9. FAQ’s ............................ 56 Legal & environment 10. Klever B Lux 25 & EC Declaration of Conformity ..............58 11. Intended use of your Klever 25 km/h E-bike................60 12. Product liability & warranty ....................62 13.
, there are two ways to activate the system: 1. Press the on/off button (image 1.3), after a 3 seconds Enjoy your Klever 25 km/h E-bike, we wish you a lot of fun, system check your E-bike is ready to be pedalled.
Page 5
Caution! The battery should only be charged with the dedicated Klever charger (image 1.4). Congratulations! With the purchase of this Klever 25 km/h E-bike you are the owner of a high-quality E-bike. For a The battery can be charged on (image 1.6) and off bike (image...
Page 6
Afterwards it has been checked • And Type-approved E-bikes with a maximum pedal assisted at your local Klever dealer. Yet, the transport and the use over speed up to 45 km/h, called speed pedelecs or speed time may have caused some changes.
Introduction Introduction 4. Behaviour in road traffi c Please note! Make sure to only use original Klever spare parts for replacement. In case you are not sure whether to use certain spare parts, always contact your offi cial With the help of the electric pedal assistance, you reach high Klever dealer or otherwise call our technical hotline.
Klever’s E-bike drive train Klever’s E-bike drive train 5. Klever’s proprietary electric Powerful system benefi ts The brushless Klever BIACTRON rear wheel motor comes with propulsion – the BIACTRON 3 powerful advantages: system 1. Contrary to centre motor drive trains, with a motor around the bottom bracket, the direct drive rear wheel motor is whisper-quiet.
5.1. Sensors and their function 5.2 Levels of electric motor support This Klever 25 km/h E-bike is equipped with a torque sensor in The BIACTRON-system off ers fi ve levels of electric motor the frame’s rear dropout. In conjunction with the pedal sensor,...
Bluetooth Turbo ( á E-KEY port The Klever BIACTRON system has a unique feature: the recovery of * Visit your dealer if the warning signal continues battery capacity, also known as regeneration. Every time the drive to appear on the display Image 5.3...
Km-day, odo, soc, kcal and cadence. See below. Please note: the available rider’s data Up arrow (↑) Middle left Increase support level may vary depending on Klever model and software version. Down arrow (↓) Lower left Reduce support level Lower left edge...
(TURBO) á power scenarios. odo (image 5.13) Accumulated kilometres during the entire lifecycle of your Klever E-bike, in this case 459 km. When the odo reaches 99,999 km. it Image 5.17 will be reset to 0. Please note! We recommend that you familiarise yourself...
Page 13
Klever’s E-bike drive train Klever’s E-bike drive train Battery consumption (image 5.22) Display Capacity The red bars show the actual battery consumption. The more 5 bars light up green ≤ 100% bars (max 5) the display shows, the more your battery is being 4,5 bars light up green ≤...
Page 14
Klever’s E-bike drive train Klever’s E-bike drive train 5.4.3. The menu and submenus for settings Press INFO (•) button for 3 seconds to enter the Settings menu 3“ Navigate with the arrow (↑) and (↓) buttons and confi rm your choices with the INFO (•)
Page 15
And both braking as well as coasting regeneration have 5 The two E-KEYs supplied with your bike are being paired with levels of regeneration: the E-drive system by your Klever dealer upon purchase. You • Automatic have two options for the E-KEY functionality: •...
When the system is switched on the headlight and tail light charging cycle means a full charge of the battery (0 – of your 25 km/h. Klever E-bike turn on automatically as well. 100% capacity). Partial charges can be done more often.
It is best to take it to one • The LED indicator turns to yellow continuous light. The of our Klever dealers, who can take care of the disposal battery is charged to about 35%. The charging is in progress.
Place the charger and battery on a clean surface. Prevent contamination of the charging sockets on the charger and the battery. Avoid humidity and direct sunlight. Please note! In case the charger is damaged, contact an authorised Klever dealer. Never open the charger. www.klever-mobility.com www.klever-mobility.com...
Page 19
This graph is only an indication of minimum, average & At low temperatures, poor weather At most favourable weather maximum ranges. Klever cannot guarantee conditions, heavy load, maximum conditions, low load, low assistance, specific ranges based on conditions that may vary per case.
As the lock and thereby protected from theft. To remove the battery, owner of a Klever E-bike you can transport the battery fi rst turn off the system using the On/Off button on the pack by road and train without limitations and any display.
Fitting the frame size to your body can be done with of the handlebar. Your Klever dealer will be happy to set the Image 6.1 adjustment of saddle, stem and handlebar. Your dealer can handlebar to your liking.
Caution! In case the brake performance is decreasing or the system shows signs of leakage, do not continue to ride your E-bike and go and see your local Klever dealer Your 25 km/h E-bike is being equipped with a suspension front immediately.
Image 6,15 the wheels, is better left to the workshop of your Klever Some minutes after you have oiled the chain, rub it with the cloth dealer. Nevertheless, in case of a puncture or in case of to remove superfluous oil from the outer surface.
Page 24
Caution! Pay attention to the correct torque for the longer sufficient, replace the tyres. If in doubt, ask your Klever assembly of the axle nuts of the rear wheel (40 Nm). Make dealer who can verify the tyre and replace it.
In Belgium and the Netherlands, you may carry children up to the age of 8 years only with a decent back support. Your Klever E-bike has a robust and durable aluminium luggage Therefore, on your E-bike carry children only with a child seat.
Please take the time to confer with your Klever dealer and carefully read through the operating manual and safety instructions of the bicycle trailer before use! Finally make sure to practice riding with the trailer on a parking lot before participating in road traffic.
Wear Maintenance Your Klever E-bike consists of many components, which are all subject to normal wear due to their function. Therefore, Regular maintenance and care guarantee a longer lifespan all following components should be regularly checked and if of your E-bike.
Your E-bike should always be stored in a dry, covered place in order to minimise the eff ects of weather and avoid direct sunlight. In case you do not ride your Klever E-bike in wintertime, you should consider following: • Store your E-bike well cleaned and lubricated in a dry place and cover it with a tarp.
(see section 5.5.2. Battery helmet? range). No, you do not need an insurance. Because the electric support will be stopped at 25 km/h, this Klever 25 km/h E-bike is classified as an EPAC, an Electric Pedal Assisted Cycle. Battery Range...
Page 30
EC Declaration of Conformity CE EC Declaration of Conformity CE 10. Klever B Lux 25 EU Declaration of Conformity The Manufacturer: Klever Mobility Inc. No. 8, Ln.76, Sec.3, Zhongyang Rd., Tucheng Dist.; New Taipei City 236 Taiwan Represented the Benelux by:...
Legal & environment 11. Intended use of your Klever 25 km/u E-bike Your Klever 25 km/h E-bike is designed according to structural requirements for a particular purpose. Thus, the usage is limited to specific areas. Your E-bike is designed based on the construction and equipment for use on public roads, normal paved roads.
A warranty claim must be notifi ed immediately. functional wear (see chapter 7. Wear), except material or product defects. Please note! In case you register your Klever battery on • In case of damages caused by faulty and inadequate care our website (www.klever-mobility.com), Klever extends and maintenance.
The same goes for batteries according to the European Directive 2006/66/ EC. Please return broken or defective batteries to an authorised Klever retailer. Transportation Only the battery is considered to be hazardous and subject to the IATA Dangerous Goods Regulation requirements during transport or shipping by third parties (agents, air transportation or mail).
Allen key 3 mm. + 5.5 Nm. Charging time: 570 Wh with 2A charger 7 hours 8 mm. open wrench Place of charging: on or off B Lux 25 Ring lock Mounting bolt 2 x M5 Allen key 4 mm.
Page 35
Gegevens Gegevens Recommended tightening torque for standardised metrical hexagon headed bolts (quality The gross maximum vehicle weight of the B Lux 25 grade 8.8) should not be more than 150 kg. = cyclist + vehicle + luggage Bout Aanhaalmoment in Nm.
Data Data 15. Klever E-bike Passport 16. Klever inspection plan Fill out all data immediately after purchase of your E-bike in order to present the pass in the case of 1. Inspection & maintenance Date: warranty claims, together with proof of purchase. In case your vehicle ever gets stolen, these data will facilitate the work of the police as well.
Need help?
Do you have a question about the B Lux 25 and is the answer not in the manual?
Questions and answers