Advertisement
Quick Links
#6068
Generation wall mount rain head
INSTALLATION GUIDE
BS03991737
BS03991737
Last revision: October 23rd
I. Installation Notice:
1. Install water supply lines in accordance with this manual.
2. Floor drain should be installed on the site.
3. Except the shower holder, all the exposed parts of the product
must be installed only after the completion of house interior
decoration in case paint or other chemicals erode the product
surface. Before that, the protective sheath on the shower holder
can not be taken off.
4. Clean pipes to get rid of mud, sand or other debris in pipes before
installation.
5. Check whether the threads can be matched. Otherwise, install
forcefully will damage the components.
6. After installation, check all the joints to make sure they are firmly
connected. Then keep water flow. Turn on and off repeatedly to
ensure there is no leakage around the joints. After that, the product
is ready for normal use.
7. Hand the manual to the user.
II. Operation Notice:
1. The product is used under water pressure 0.1~0.5MPa, water
temperature 4~70°C.
2. Do not hang heavy things on the product.
3. Remember to turn off the mixer when no water comes out of it,
especially when nobody in the house or during the decoration period or
power off.
4. Clean the surface of the product regularly to keep it bright.
Note: Please do not use inappropriate tools such as sharp brushes,
rough sponges, scouring pads or corrosive detergent. And it is not
recommend to use the detergent sold in the market, because its
formula changes frequently. Please clean the product with wet cloth and
soapy water after some time of usage. Then rinse the soap out with
clean water and dry with a soft cotton cloth.
5. Adjust the temperature before use, then open the cold and hot water in
turn. To avoid scald, do not stand right below the shower head.
6. Do not disassemble the product without help from the professionals.
III Installation Diagram:
IV Installation Steps (Fig.1~20)：
Drill
Level Bar
S7 Wrench
(supplied)
Pencil
The installation diagram is only for reference,
the product is subject to the real object.
Prepare below tools
Safety Goggle
Phillips Screwdriver
S2.5 Wrench
(supplied)
Teflon Tape
Advertisement
Summary of Contents for Ca'Bano 6068
- Page 1 III Installation Diagram: #6068 Generation wall mount rain head INSTALLATION GUIDE BS03991737 BS03991737 Last revision: October 23rd I. Installation Notice: IV Installation Steps (Fig.1~20)： The installation diagram is only for reference, the product is subject to the real object. 1. Install water supply lines in accordance with this manual.
- Page 2 Wrap teflon tape around the 90° elbow. Then screw it into the shower holder. Attention:keep two open ends face downwards. Self-tapping Screws Shower Seat 90° Elbow Insert the anchors into Ø8 holes. Anchors Lightly fix the shower holder to wall by self-tapping screws.
- Page 3 Cover the ceramic Install the escutcheon to the tiles on the wall, shower arm. pay attention to the installation depth. Reference line of finished wall Shower Arm M3 Screw Escutcheon Take off the protective Remove the protective sheath and plug. sheath from the shower arm and connect the shower arm with the...
- Page 4 Tighten M5 screw Loosen M5 screw by by S2.5 wrench. S2.5 wrench and carefully take off the shower head. M5 Screw M5 Screw Shower Head When completed, run water Screw off the to check if the installation is connecting pipes proper.