Download Print this page

Edmo GAYA VANITY UNIT Instruction Manual

Wall-fixing

Advertisement

Quick Links

INSTRUCTION FOR WALL-FIXING OF VANITY UNIT "GAYA"
Vanity unit Gaya with 2 drawers L.(cm. 60-23
Suggested dimensions for wall-fixing of Gaya Vanity units
) (cm.70- 27
5/8
13
605-23
16
3
705-27
4
5
905-35
8
3
180- 7
32
) (cm.90-35
9/16
7/16
Page. 1
)

Advertisement

loading

Summary of Contents for Edmo GAYA VANITY UNIT

  • Page 1 INSTRUCTION FOR WALL-FIXING OF VANITY UNIT “GAYA” Vanity unit Gaya with 2 drawers L.(cm. 60-23 ) (cm.70- 27 ) (cm.90-35 9/16 7/16 Suggested dimensions for wall-fixing of Gaya Vanity units 605-23 705-27 905-35 180- 7 Page. 1...
  • Page 2 Before You start: During unpacking, please check-up the product, if it is complete and not being damaged. • Supplied supporting brackets/fixings system and screws are only for solid, full wall. Take care, by yourself, that you are • using the right screws for wall type – in case of doubts, please consult professional staff. Clean the room and the surface, the area must be dry and without dust or powder.
  • Page 3 Before installation of Vanity unit, you must remove and pull out the drawers. 1) Remove the plastic cap with a screwdriver and push the level-hook upward. 2) Pull out the drawer by pulling it towards yourself and upward, keeping pushed down the 2 levels-hook, hereinafter push the guides towards inside the cabinet, so you avoid to crash against them during assembly.
  • Page 4 4) Hang the Vanity unit to the wall, by means of suitable wall brackets, which are already fixed at each side of the unit. 5) Adjust the height of the Vanity unit, turning the screw (B) of both supports till furniture is at right horizontal level. Hang the furniture, hooking the brackets onto wall-mounting plates and turn the screws (A) belonging to the furniture brackets.
  • Page 5 7) For convenience you may unhook the Vanity unit from the wall, after marking the holes positions. Make the holes with the drilling machine, where previously indicated with the pencil, insert the appropriate supplied dowels in the wall-holes and adjust the supporting brackets, turning the screws. 8) Replace the Vanity unit to its original position.
  • Page 6 Unhook and adjust the drawer 11) to unhook the front, turn the indicated screw. 12) to adjust the front height, turn the indicated screw. 13) to adjust horizontally the drawer-front, turn the screw as indicated. 14) When you end all the adjustments arrangements, re-install the plastic cover as in picture indicated. Thank You to have chosen our bathroom furniture! Page.