Advertisement
2. SPECIFICATIONS & ASSEMBLY
Ceramic plaques provide fast and efficient transfer of heat. Elements are
switchable between 800, 1600 and 2400Watts and are fully guarded.
Lightweight, portable and suitable for industrial or domestic applications.
Heater is fitted with an automatic cut-out should it be tipped over.
2.1. SPECIFICATIONS.
Power output . . . .800/1600/2400Watts
Input . . . . . . . . . . . . . . .230V. 10.5Amp
Weight . . . . . . . . . . . . . . . . . . . . . .6kg
Width . . . . . . . . . . . . . . . . . . . .400mm
Length . . . . . . . . . . . . . . . . . . .365mm
Height . . . . . . . . . . . . . . . . . . .525mm
2.2.
ASSEMBLY
Check the heater to ensure it is in good condition and not damaged.
Fix the two leg supports (fig 1.1) to the side of the heater with washers and screws provided.
DO NOT use the heater without the supporting legs fitted.
3. OPERATING INSTRUCTIONS
WARNING! Ensure you read, understand and apply safety instructions.
3.1.
Fully unwind the power cable and check it and the plug are in good condition.
3.2.
Plug into the mains power supply.
3.3.
Set switches to the required output power, see figure 2.
800W (low) turn switch A to On and B to Off
1600W (medium) turn switch A to Off and B to On.
2400W (Full) turn switch A to On and B to On.
Note: If tipped over, a cut-out device will automatically switch the heater off. When the
heater is placed in the correct position it will automatically restart .
WARNING the heater surfaceces may be hot.
4. MAINTENANCE
F
WARNING! Before attempting any maintenance ensure the unit is unplugged from the mains power supply and that it is cool.
4.1.
Clean the heater with a soft dry cloth. DO NOT use abrasives or solvents.
p
4.2.
Periodically remove the element guard and clean the reflector panels behind the heating elements. Refit the guard before use.
4.3.
Periodically check the heater grills to ensure they are not blocked.
No other maintenance is necessary. If you experience a problem with your heater or if the power lead or plug is damaged contact your local
authorised service agent for repair. DO NOT dismantle or tamper with the heater as this may be dangerous and will invalidate your warranty.
Declaration of Conformity We, the sole importer into the UK, declare that the product listed below is in conformity with the following EEC
standards and directives.
ELECTRICAL CERAMIC HEATER
Model CH2400
73/23/EEC Low Voltage Directive (S.I. 1994/3260)
EN60335-1 and EN60335-2-30
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts
without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: Call 01284 757525 for our catalogue & promotions. Leave your full name, address & postcode.
01284 757500
The construction file for this product is held by the Manufacturer and may
be inspected by a national authority upon request to Jack Sealey Ltd
Signed by Mark Sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products
Sole UK Distributor,
Sealey Group, Bury St. Edmunds, Suffolk.
01284 703534
fig 1
fig 2
21st September 2000
E-mail: sales@sealey.co.uk
CH2400 - 0009 - (1) - 210900
Advertisement
