PEERLESS Armor Lock Plus ACC 020 Installation And Assembly

Installation and Assembly -
™
Vector Pro , Vector Pro Plus
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
Before you start check the parts list below to make sure all of the parts shown are included.
Parts List
Description
AA cable assembly, with loop end
BB 4 mm security allen wrench
CC #10-32 serrated washer head socket pin screw
DD cable adapter (for use with Encore Mounts only)
EE PRS interface plate (for use with PRS-1 Mounts
only)
Note: Actual parts may appear slightly different than illustrated.
If installing the security cable onto an Encore Mount, skip to step 2.
If installing the security cable onto an PRS-1 Mount, skip to step 4.
If installing the security cable onto a Vector Pro and Vector Pro Plus
Mount, align holes of bracket from cable assembly (AA) to holes on
PJC 100 as shown in detail 1. Fasten cable assembly (AA) to PJC 100
with two #10-32 serrated washer head socket pin screws (CC), and
tighten using 4 mm security allen wrench (BB).
Insert key into lock. Then insert lock into slot on projector and turn key
counterclockwise 90° to lock. Remove key.
Note: If needed, when installing the cable assembly (AA), wrap the
cable around the PJC 100 to reduce slack in the cable.
Visit the Peerless Web Site at www.peerlessindustries.com
Armor Lock Plus ™
™ ™
, Encore or PRS-1 Projector Mounts
Part Number
Qty.
1 600-0032
560-9646
1
2 510-1121
1 055-1010
580-1070
1
PJC 100
1 of 3
Security Cable with lock for the
AA
ISSUED: 09-30-02 SHEET #: 055-9109-5 12-22-04
For customer service call 1-800-729-0307 or 708-865-8870.
Model: ACC 020
BB
CC
DD
EE
BRACKET
AA
DETAIL 1
CC