Graco MAGNUM 289680 Instructions

Instructions
Enclosure Replacement Kit for
X5, X7, LTS 15, and LTS 17 Sprayers
This manual contains kit installation instructions only
Enclosure Replacement Kit: 289680, 289681
Important Safety Instructions
For detailed sprayer information and warnings, see
Operation manual 312001 or 313034 included with Magnum sprayers.
Pressure Relief Procedure
To help prevent injection injuries, follow this
procedure when you stop spraying and
before you service or clean the sprayer,
remove parts, or repair leaks.
1. Turn Power switch OFF. Unplug sprayer.
2. Turn Spray/Prime valve to PRIME to relieve pres-
sure. Turn pressure control knob left (counterclock-
wise) to minimize pressure.
3. Trigger gun.
4. Put trigger safety in safety ON position.
NOTE: Leave Spray/Prime valve in the
PRIME position until you are ready to spray
again.
If you suspect that the spray tip or hose is completely
clogged or that pressure has not been fully relieved
after following the steps above, VERY SLOWLY loosen
the tip guard retaining nut or hose end coupling to
relieve pressure gradually. Then loosen it completely.
Clear the tip or hose obstruction.
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2007, Graco Inc. is registered to I.S. EN ISO 9001
ti11868a
312930A
ti11904a