Table of Contents
Advertisement
en Rinse aid system
Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
indicator off.
Note
To avoid damage to the appliance, only
switch off the water softening system in
the following cases:
¡ The water hardness is max. 26 °E
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
erally only be used up to a water
hardness of 26 °E without adding
special salt.
¡ The water hardness is 0 - 8 °E.
You do not need to use special
salt.
Press
.
1.
To open the basic settings, press
2.
for 3 seconds.
a The display shows Hxx.
a The display shows
Press
repeatedly until the dis-
3.
play shows H00.
To save the settings, press
4.
for 3 seconds.
a The water softening system is
switched off and the salt refill indic-
ator is deactivated.
Rinse aid system
Rinse aid system
Rinse aid system
Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
26
.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
Press the catch on the lid of the
1.
dispenser for rinse aid
.
Add rinse aid up to the max mark.
2.
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Close the lid of the dispenser for
4.
rinse aid.
a The lid clicks into position.
and lift
2
1
max
Advertisement
Table of Contents
