Water Draining; Troubleshooting - BEMIS bioBidet Bliss BB1700 Owner's Manual

WATER DRAINING

Draining the Warm Water Tank in the Unit
Do not drink the drained water. Do not insert finger into the drain
hole. Before draining, unplug the power cord and wait 30 minutes
until the unit has cooled down.
If you do not intend to use this
product for 14 days or longer,
Drain the water from this product's
warm water tank.
1. Disconnect the power plug.
2. Close the water shut
off valve.
3. Press the drain lever until the
water is completely drained
from water tank.
4. To re-supply water after
draining,open the water
shut off valve.
Maintenance For Winter Season
1. Check the power cord if it is plugged in or not.
2. Keep the water temperature on "Middle or High Level"
to prevent water from freezing.
3. If you do not intend to use the unit for 14 days or longer,
disconnect the power plug and drain the water.
32

TROUBLESHOOTING

Trouble Cause
1. The water tank
is not filled.
The
2. The shut off valve
washing
is closed.
water 3. Freezing inside the
main unit or the water
does not
supply pipe.
spray
1. Disconnected the
power cord.
The unit
2. The seat is not
is not
occupied.
operating
3. The battery of remote
controller is exhausted.
Water is Check the water
supply system
leaking
1. The water pressure
The washing
level is set to "LOW".
2. The strainer is clogged.
water pressure
is weak
1. The water temperature
The washing
is set to "LOW"
water is not 2. Continuous operation
has depleted the
warm
supply of warm water.
The seat and The seat & dryer
temperature is set to
dryer is not
"LOW"
warm
Remedy
1. Wait about one minute.
2. Press the desired washing
button once again.
3. Turn on the shut off valve
to open.
4. Heat the room
(for about two hours).
Operating the unit while
parts are frozen will cause
a malfunction.
1. Connect the power cord.
2. Check the power supply
system in your house.
3. Occupy the seat (The unit
has an occupied sensor).
4. Replace the battery.
If water is leaking from the
main unit, call the service
center or the place you
purchased unit.
1. Set the water pressure
to "HIGH"
2. Clean the strainer.
1. Set the water
temperature to "HIGH"
2. Wait about three minutes.
Set the seat & dryer
temperature to "HIGH"
33