Sanyo EM-D971EES Service Manual page 18

E. REMOVING DOOR
(1) Remove the 2 screws securing the upper hinge.
(2) Tilt the top of the door toward you.
(3) Lift up the door to remove it.
NOTES
- After replacing the door, be sure to check that the
primary interlock switch, door sensing switch and the
interlock monitor switch operate normally. (See
page 1).
- After replacing the door check for microwave energy
leakage with a leakage detector.
Microwave energy leakage must be below the limit of
2
5mW/cm .
F. DISASSEMBLYING DOOR
( See exploded view on page 22)
(1) Insert a thin flat blade screwdriver between the
choke dielectric and the door mainframe and lift
up the choke dielectric to release the hooks one
by one.
(2) To remove door cover, remove the 3 screws
securing the door cover to the door main frame
(3) Insert a thin flat blade screwdriver between the
door cover and door mainframe and release the
hooks one by one.
(4) To detach the glass door panel, insert a thin flat
blade screwdriver between the door panel and
door cover and release the clips one by one.
NOTES
- The choke dielectric, the glass door panel and the
door cover may be damaged when they are removed.
When re-installing them, replace them with new ones
if they are damaged.
- After installing the door in place, check for microwave
energy leakage with a leakage detector.
Microwave energy leakage must be below the limit of
5mW/cm 2 .
G. CHANGING POWER SUPPLY CORD
(See exploded view on page 20 )
(1) Remove the earthing screw.
(2) Remove the power supply cord from the terminal
of PCB complete.
(3) Remove power cord from cavity assembly by
lifting cord bush, moving it to the left and pulling it
away from cavity rear plate.
(4) Install the new power supply cord with the
reverse procedure of above (1) to (3).
WARNING
For changing the power supply cord, never use parts
other than the following :
Part Name : Power Supply Cord Assembly
Part No : 617 169 9609
Part No : 617 186 9620
H. REMOVING TURNTABLE MOTOR COVER
(Refer to Figures 13 and 14 below )
RE-INSTALL :
Metal Tabs
EES/ESE/ESP/ESF
EIL
-17-
(1) Turn the unit and cut the 6 joints of the bottom
plate and the motor cover using diagonal pliers
(nipper). (See Figure 13 )
(2) Seperate the motor cover and the bottom plate.
NOTES
- Bend the cut joints inside slightly for safety and be
careful of the sharp edges.
(1) Rotate the motor cover through 180˚.
(2) Insert the edge of the motor cover into the tab on
the bottom plate.
(3) Secure the motor cover by screwing it to the
bottom plate (See Figure 14 )
Use screw 411 156 5502 (not supplied with oven)
Clip metal here
and at other 5
locations.
Retaining Lugs
Figure13
Insert screw here to
secure.
Tabs fit into
retaining lugs.
Figure14