MAXHUB Classic Series User Manual

V5 Interactive Intelligent Panel
Classic, Vogue and Transcend Series
User Manual
Thank you for choosing MAXHUB product.
Please read carefully and thoroughly this document before using the product. Should you have
any questions, please contact technical support.
Safety Warnings
Placement
(1) Please do NOT place the product on a slope, mount on an unstable stand or an insufficiently
robust wall, a table nor a shelf.
(2) Please do NOT expose the product to direct sunlight or any other heat source.
(3) Please do NOT put the product near devices that generate strong magnetic fields.
(4) Please do NOT place the product in a humid environment for it is NOT water-proof. Keep it
from water splashes.
(5) Please do NOT place any other heavy objects on the product.
Power
(1) Please check the product's operating voltage and frequency matches the local power
configuration.
(2) Please unplug the device during storming or thundering weather.
(3) Please unplug the power should the product is left unused for long time.
(4) Please keep the power cable from physical or mechanical damage.
(5) Please use the MAXHUB cable and do NOT modify it.
(6) Please make sure the AC is grounded.
Screen
(1) Do NOT use hard nor sharp objects on the screen other than MAXHUB stylus.
(2) Please unplug the power before cleaning the product.
Please clean the screen with a soft, dustless and dry cloth.
(3) Please do NOT use water or liquid detergent to clean the product.
(4) Please contact the authorised reseller for thorough cleaning.
(5) Please do NOT display a high-brightness image on the screen for too long time.
Viewing Distance
The optimal viewing distance is 3-4 times the diagonal length of the screen.
Temperature & Humidity
(1) Please do NOT put the product near a heater nor a radioactive source.
(2) If the product is moved from a cold place to a warm one, please unplug the power cable and
allow the product to gradually warm up for at least two hours to reduce the moisture.
(3) Operating temperature of the product is 0°C-40°C, operating humidity is between
0%-90%RH.
Ventilation
Please place the product in a place with adequate ventilation. Leaving at least 10cm-space on the
left, right and back, and 20cm-space above the product.
Earphone
It may cause temporary or permanent hearing loss should you listen to the earphone in high
volume.
Please turn down the volume before you put on the earphone.
Standby
Pressing on the power button shortly will not shut down the product. It will enter standby mode
with only the screen turned off. To shut down the product, press and hold the power button for
approximately 3 seconds and confirm the shut down command in the centre of the screen.
Notes for Cleaning
The back panel included a number of heat vents. Please do NOT spray any liquid.
Rocker Switch Status
"I" means on, "O" means off.
Maintenance
Please contact authorised reseller for maintenance or repairing.
Warranty Exclusions
MAXHUB does not warranty Products that match any one or few of the following descriptions:
(1) Product damages caused by violating the user manual.
(2) Hardware damages caused by improper setup.
(3) Product damages caused by unauthorised modification or maintenance.
(4) Product damages caused by using in an unsuitable environment.
(5) Product damages caused by abnormal external force.
(6) Product damages caused by natural disasters or other force majeure.
(7) Damaged Warranty Sticker
(8) Unable to provide effective purchase certificate
I. Power On/Off
Plug the power cable into the power
socket of the product.
Plug the power cable to the power supply.
Press the power button to boot the
product.
Flip the rocker switch and press on power
button to boot the product. The indicator
would turn blue.
II. External Touch Connection & Wireless Screen-sharing
HDMI IN TOUCH
There are two ways for connecting with an external device such as a laptop:
(1)Connect the laptop with an HDMI cable, a USB Type A male to USB Type B male cable and an
audio cable.
(2)Screen-share with MAXHUB Share application. Get to know more from MAXHUB Share User
Manual.
In either way you may set the interactive flat panel as another display.
• Display: You may duplicate the displaying contents on the laptop or use the panel as an
extended display.
• Sound: You may also choose to play sound from the interactive flat panel.
• Touch Control: You may achieve touch control on the panel once the above-mentioned USB
cable is connected or finished relevant settings while using MAXHUB Share App.
III. Button & Port Description
Press to boot or turn off the display. Press and hold for three seconds to shut
down the product.
USB
USB Port for both Android and Windows OS.