Advertisement
Quick Links
™
GROW-DISK
Feed System
Grow-Disk Feed System Maintenance/Troubleshooting
Caution: Disconnect power before performing any maintenance
Daily Inspection
• Monitor system amperage load
Monthly Inspection
• Open unit and remove feed residue/check chain tension
Every 6 Months Inspection
• Remove dust from drive unit ventilator
• Check functioning of safety switch
• Check proximity switch
• Check any/all other safety devices or sensors
Once a Year Inspection
• Check idler wheel and drive sprocket for wear
• Check corners. Remove residue. Verify tube position
• Check system wiring for damage
Hog Slat Inc. Newton Grove, NC USA June 2015
1
Advertisement
Summary of Contents for Hog Slat GrowerSELECT Grow-Disk
- Page 1 • Check any/all other safety devices or sensors Once a Year Inspection • Check idler wheel and drive sprocket for wear • Check corners. Remove residue. Verify tube position • Check system wiring for damage Hog Slat Inc. Newton Grove, NC USA June 2015...
- Page 2 Drive unit motor always shuts off Proximity switch sensitivity not Adjust sensitivity immediately after proximity by-pass adjusted properly (Too sensitive) time Part Number: HSMANUAL-069 Rev IR Market: Hog Hog Slat Inc. Newton Grove, NC USA June 2015...
Need help?
Do you have a question about the GrowerSELECT Grow-Disk and is the answer not in the manual?
Questions and answers