Using Instructions - TECNOVAP HYDROBOX 10.7 Manual

7. USING INSTRUCTIONS

(a) After opening the packaging, insert the manoeuvring handle (01) in the relative seat and secure in
place with the fixing screw (02).
(b) Connect the hand grip to the appliance (03) and insert one of the available lances (23) by screwing
the fixing ring to secure everything;
(c) Connect the appliance to the water supply (04) as indicated in chapter 3;
(d) Insert the power cable (05) in a power outlet, making sure that the voltage and amperage
correspond to the values provided on the machine data plate;
(e) Switch on the appliance by turning the main switch (06) to ON position and activate the boiler switch
as well as the pump switch
Warning!!
Operating the lever (22) on the hand grip (20) will cause the release of superheated high-
pressured water with up to a temperature of 90°C, be very careful that this lever is not
activated inadvertently and that the water jet is never directed towards persons or animals.
Partial counter reset
The switched-on appliance (ON) should be in standby mode (OFF on the display), then press and
hold the temperature switch
"C A L C" signal reset
After maintenance, carried out by the user, switch on the appliance and activate the boiler switch
as well as the pump switch
, the wording "C L R" will immediately appear on the display and the appliance is thus resetted.
.
until the wording "C L R" appears on the display.
. Press and hold the boiler switch
Pag. 12
HYDROBOX
and press the pump switch
TECNOVAP 36/18