Mitsubishi HC6800 User Manual page 27

Menu operation (continued)
2. INSTALLATION menu
opt.
A V MEMO R Y 1
INSTALLATION
KEYSTONE
LAMP MODE STANDARD
AUTO POWER
ON
AUTO POWER
OFF
SPLASH
ON
SCREEN
BACK COLOR
IMAGE
REVERSE
TRIGGER OUT
TEST PATTERN
CROSS HATCH
LENS LOCK
2. INSTALLATION menu
ITEM SETTING
KEYSTONE
LAMP MODE STANDARD
LOW
AUTO POWER ON ON / OFF
AUTO POWER OFF OFF / 5 - 60min
SPLASH SCREEN ON / OFF
BACK COLOR BLUE / BLACK
IMAGE REVERSE
MIRROR
INVERT
MIRROR INVERT
TRIGGER OUT SCREEN
ANAMORPHIC
TEST PATTERN CROSS HATCH
WHITE
BLACK
LENS LOCK ZOOM/FOCUS LOCK
LENS SHIFT LOCK
LENS SHIFT RESET
• When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW about one minute
after turn-on.
• When the lamp mode is switched, the projected image may flicker. This is not a product malfunction.
• Do not change the setting of LAMP MODE frequently.
• To cancel the test pattern, press any button.
0
OFF
OFF
ON
BLUE
OFF
OFF
OK
FUNCTION
±15 Use to correct vertical keystone distortion.
Select this option when you want to view images in a well-lit room.
Select to moderate the intensity of the lamp. The fan operating sound is
reduced and the lamp lifetime becomes longer.
When ON is chosen, the lamp is automatically lit when the power cord is
plugged in the wall outlet. Choose ON when using the projector mounted on
the ceiling.
• The projector is in the stand-by mode when the lamp is off. Use the remote
control to turn on the lamp.
Use to set the time elapsed before the projector enters the stand-by mode
when there is no signal input from the source.
Choose ON to display the splash screen when the power is turned on.
Use to change the color of the screen that appears when no signal is supplied.
OFF Select when viewing images from the front with the projector installed on the
floor.
Select when viewing images projected from the behind of the screen with the
projector installed on the floor.
Select when viewing images projected from the behind of the screen with the
projector installed on the ceiling.
Select when viewing images from the front with the projector installed on the
ceiling.
The trigger output signal (12 V) is output from the TRIGGER terminal when the
lamp illuminates.
The trigger output signal (12 V) is output from the TRIGGER terminal when the
aspect ratio is set to ANAMORPHIC 1 or ANAMORPHIC 2.
OFF
The trigger output signal (12V) isn't output.
Select to show the test cross hatch pattern.
Select to show the maximum brightness image.
Select to show the minimum brightness image.
Use to enable or cancel the FOCUS LOCK and ZOOM LOCK.
Use to enable or cancel the LENS SHIFT LOCK.
Use to reset the position of the lens to the factory setting.
EN-27