Beacon TSL VISOR Installation Instructions

TSL VISOR INSTALLATION INSTRUCTIONS. IMPORTANT
INSTALLATION INSTRUCTIONS
TSL LASER AIMING DEVICE
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes.
Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and
use so fixture failures do not cause a hazard and use only in environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding
luminaire operation and burning position. Luminaire label shows electrical and environmental requirements and
restrictions.
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat
retention. Dusting with a soft, clean, dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt
should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any
work, contact your distributor or Lightingtechsupport@currentlighting.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.

Installation Steps:

•
Remove aiming device (See Fig.
1) from carton and unscrew the
back of the device that includes the
on & off button.
•
3 batteries have been provided in
the carton. Place all 3 in the device
and reinstall the back. When new
batteries are required use AG13
button cells.
•
Warning! AVOID EXPOSURE TO
BEAM. THIS IS A CLASS 3B LASER
PRODUCT. Point the laser away
from you and never point it at
another person or animals.
•
You can select from two areas to
mount the device. See position "A"
or "B".
•
Using the provided 3mm hex key,
install the device onto the TSL
fixture and tighten the provided M4
Screw into the threaded hole.
•
Aiming device should be removed
from the fixture and batteries also
removed when not being used.
Current Lighting • 701 Millennium Boulevard • Greenville, SC 29607 • Phone: 864-678-1000
©2022 HLI Solutions, Inc. All Rights Reserved. Information and specifications subject to change without notice.
All values are design or typical values when measured under labarotory conditions.
SAFEGUARDS
SAVE THESE INSTRUCTIONS.
READ THOROUGHLY BEFORE INSTALLATION
Unscrew this
area to install
Laser End
the batteries.
of Device
On & Off
Button
M4 Screw
Laser Aiming
Device (FIG. 1)
READ AND FOLLOW ALL

SAFETY INSTRUCTIONS.

Position-A
93156983 Rev B - Page 1 of 2
Position-B
www.beaconproducts.com