Advertisement
Quick Links
Advertisement
Summary of Contents for RAKIRO AQUASOL AM-AL-01
- Page 1 AM-AL- 01 User's Guide Multi Parameter Handheld Meter pH/ORP/Conductivity/TDS/Salt/Temp...
- Page 3 Introduction : We thank you for having purchased Multi Parameter Handheld Meter. Before using the instrument, please read the operation instructions carefully, which will help you to operate and maintain the instrument, as well as to avoid trouble caused by unsuitable operation and maintenance.
- Page 4 Specifications : Temp. Range -2.00~16.00 pH -1999 ~ -200 mV -199.9 ~ 499.9 mV 500 ~ 2000 mV 0~110 °C Accuracy ±0.01+1 digit ±2+1 digit ±0.2+1 digit Resolution 0.01 pH 0.1/1 mV 0.1 °C Compen- ATC: 0~100 °C sation Conductivity Salt Range 0.0~ 199.9 S...
- Page 5 Display Description : 1. Function Mode 2. Measuring Reading 3. unit 4. Calibration Mode 5. Calibration error indicator 6. Battery power low Indicator 7. Temperature Indicator 8. Auto Temperature Compensation...
- Page 6 Collar Soaking bottle 3-in-1 electrode Protection cap...
- Page 7 Functions of Keyboard : Choose different function mode. Press 3 sec. to switch °C/°F Turn on or off power. Press 3 sec. to enter calibration mode Preparation: 1. Remove the protection cap and protection bottle from the electrode. 2. Rinse the electrode with clean water and wipe it dry.
- Page 8 Calibration: <pH> 1. Make sure the sensor is 3-in-1 electrode, remove the soaking bottle, and switch to pH mode. 2. Dip the electrode into the buffer solution pH 7.00. Stir gently and wait until the reading is stable. Press and hold 3 sec.
- Page 9 <COND, TDS, Salt> 1. Make sure the probe is 3-in-1 electrode, remove the soaking bottle, and switch to Conductivity mode. 2. Dip the cell into the standard solution 1413 ì S/cm. Stir gently and wait until the reading is stable. Press and hold for 3 sec.
- Page 10 Measurement : <pH> 1. Press to choose pH mode. 2. After calibration, rinse the 3-in-1 electrode with clean water and wipe it dry. Dip the electrode into the sample solution which is going to be measured. Stir gently and wait until a stable reading can be obtained.
- Page 11 Battery Change : 1. Please loosen the collar, and remove the electrode. 2. Lift the battery cap to open it. 3. Please mind the polarity of the batteries when install them into the meter. Battery Cap...
- Page 12 Multi Parameter Handheld Meter pH/ORP/Conductivity/ TDS/Salt/Temp...