3.
communication cables (F1, F2) to the terminals on the back of the front cover while adjusting to a suitable
length.
4.
6 N·cm or less.
• You can connect up to 16 indoor units to a Wi-Fi Kit.
NOTE
10 and over
10 and
over
50 and over
Back cover
Be sure to secure space of at least
10 mm (up/right/left) and 50 mm
(down) around the back cover
the wall.
Item
Power/communication terminals
Tracking/Reset button
Micro SD card slot
5. Assemble the Wi-Fi Kit again.
•
make sure that there is no gap between the covers.
NOTE
Unit: mm
10 and over
Screw
holes
Fix the screws to the
screw holes.
Contents
Do not over-tighten the PCB
terminal.
Item
LED
Network PBA
Interface module PBA
Indoor unit
Wi-Fi Kit
ⓐ
PCB port
Contents
7