Table of Contents
Advertisement
Quick Links
Introduction:
The ECCO DS1500 is a solid-state reverse motion sensor which can be used
on vehicles with any type of speedometer, including electronic. It activates the
back-up alarm every time the vehicle moves backwards, in any gear, ignition
on or off. The DS1500 meets the California alarm device requirements for
refuse trucks.
IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be
delivered to the end user.
WARNING!
Failure to install or use this product according to manufacturers recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
LAB-107 Rev F
Installation and Operation Instructions
Directional Sensor
Page 1 of 4
Advertisement
Table of Contents
Summary of Contents for Ecco DS1500
- Page 1 Directional Sensor Introduction: The ECCO DS1500 is a solid-state reverse motion sensor which can be used on vehicles with any type of speedometer, including electronic. It activates the back-up alarm every time the vehicle moves backwards, in any gear, ignition on or off.
- Page 2 ECCO immediately. Installation: The magnets in the DS1500 sensor system may be mounted using either the “tape-on” method (A), where the magnets are taped directly onto the drive line, or the “bolt-on” method (B), where the magnet assemblies are bolted onto the U-joint caps.
- Page 3 Sensor Mounting: NOTE: The design of the DS1500 has changed. If replacing or When installing the DS1500 sensor to the mounting bracket, installing this sensor/magnet for the first time, please be use hand tools only. Do not use pneumatic or electric power sure to follow the gap adjustment instructions in 4.
- Page 4 This Limited Warranty defines specific legal rights. You may have other legal rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages. 833 West Diamond St Boise, Idaho 83705 Customer Service USA 800.635.5900 UK +44 (0)113 237 5340 AUS +61 (0)3 63322444 www.eccogroup.com ECCO © 2006 LAB-107 Rev F Page 4 of 4...
Need help?
Do you have a question about the DS1500 and is the answer not in the manual?
Questions and answers