– the oven on the table". ® This is the starting point for the "K|POT Our solutions guarantee high quality, safety and, above all, excellent energy efficiency and cost effectiveness. THE INTELLIGENT BUFFET SOLUTION + THE MAGIC OF INDUCTION Contents Revision index ..............................
Page 3
Clean and service plastic parts ........................37 Ensure preservation of the product identification..................... 37 Keep ready for next use in dry condition ......................37 Fault – What now? ............................38 Warranty and liability ............................ 39 ...
Our customers often express the wish to have one compact guide instead of a number of different guides for these product variants, which have similar functions. If there are any shortcomings from your point of view, please do not hesitate to let us know. We endeavour to become even better with your help.
Failure to follow these warning instructions may cause serious bodily injury or even death. CAUTION indicates a potentially harmful situation. Failure to follow these warnings may cause minor bodily injury. Rieber GmbH & Co. KG...
Always use a lid for heating food or keeping it warm. The hob and the bottom of the cooking vessel must always be clean and dry. Do not use cooking vessels made of plastic, porcelain or aluminium foil.
Page 7
Comply with the locally permissible connected load. ► Avoid switching a large number of appliances on/off at the same time. ATTENTION ® thermoplates can be damaged by overheating. ► ® Please observe the thermoplates instructions. Rieber GmbH & Co. KG...
Page 8
The operator must have all safety equipment checked regularly for completeness and proper function. • The operator must ensure that the required media connections are available. • The operator must ensure that all safety-relevant measures required on site are taken. Rieber GmbH & Co. KG...
The state of the hot heating surface is not visible. ► Where possible wear protective gloves. ► Keep unauthorised persons away from the appliance. ► Never operate the appliance unsupervised. ► Keep flammable materials away from the product.
Page 10
We recommend that the operator takes the following precautions: ► Keep persons with a pacemaker away from the appliance initially. Identify this workplace where necessary. ► Have the doctor clarify the actual situation and individual compatibility where necessary.
Page 11
WARNING ® Danger of cuts from damaged Ceran glass surface. Sharp and pointed edges can cause cuts. ► ® If the Ceran glass surface is damaged, disconnect the appliance from the mains supply immediately. Rieber GmbH & Co. KG...
This appliance may be used by children over 14 and by persons with limited physical, sensory and intellectual abilities or a lack of experience and/or knowledge if they are supervised or if they were instructed in the safe use of the appliance and have understood the resulting dangers.
• To avoid risks to persons with pacemakers, the use of appliances with inductive heating in public areas or for self-service is only allowed under supervision. Keep people away from the appliance. • Keep magnetically-sensitive objects such as credit cards and phone cards away from appliances with inductive heating.
• Never operate the appliance with an empty cooking container. • After 3 hours the total permissible regenerating and keep-warm time according to the health requirements is reached. Comply with the HACCP requirements. • Do not use to heat up a room.
Indicator light showing operating state Product identification: Type plate Switched ON/OFF (option) Rubber feet Retractable power regulator 10 ON/OFF rocker switch including red Product identification (option) indicator light on the underside of the appliance (option) Rieber GmbH & Co. KG...
1/1 coolSWISSPLY 1/1 hybrid-SP-i Power [W] Refrigeration capacity 150 watts Power for cooling function 150 W at VT 10 °C, Power for keep-warm function 500 W room temperature around 20 °C Power generation Refrigeration unit. Refrigerant Refrigeration unit. Refrigerant R134a R134a...
Page 17
Dimensions: L x W x H) 603 x 398 x 218 mm Cooling/keep-warm surface: L x W = 497 x 292 mm; Function field: L x W x H= 567 x 362 x 152 mm Control housing: L x W x H= 388 x 119 x 100 mm; Ventilation grille: L x W = 500 x 82 mm ®...
Note Before First Use Cooking units, accessories and their use User tip With the optimal accessories the K|POT - is energy-saving and the possible applications can be extended. ® The GN saucepan thermoplate prevents food from overboiling or burning. Use of the buffet lid creates the perfect serving situation.
➢ Keep unauthorised persons away from the appliance. Never operate the appliance unsupervised. ➢ NEVER pour oil or grease into an empty heated-up pot or pan, as there is a risk of burns and fire.
➢ WARNING Risk of burns Keep metal objects such as watches, rings, cutlery and tins away from the cooking zone. These could be heated up very quickly. ➢ Only use induction-compatible containers such as GN containers, pots and pans for induction cooking appliances.
Page 21
Every dish heats up differently. ► Test the settings before using the buffet. ► Check the temperature. User tip for saving energy ® ➢ Use the thermoplate with a lid. ➢ Occasional stirring will ensure even temperature distribution. Rieber GmbH & Co. KG...
OFF (option). Equip the appliance with suitable accessories User tip With the optimal accessories the K|POT - is energy-saving and the possible applications can be extended. ® The GN saucepan thermoplate prevents food from overboiling or burning. Use of the buffet lid creates the perfect serving situation.
Indicator light showing operating state → The indicator light is lit when the appliance is electrically activated and the power regulator is not in position "0. Lead with connector ® # Intended use of the K|POT 1/1 ch-800 • For keeping hot food warm.
Lead with connector Overview of program settings # Intended use of the K|POT … ck-… • Keep-warm settings 1 to 3 for keeping hot food warm. • Programs P1 to P6 for automatic regeneration of pre-prepared food. • Power settings 4 to 6 for steaming, cooking and baking.
Page 25
/ regenerating for heating / regenerating for keeping warm small quantities large quantities. ➢ Press and YELLOW LED RED LED RED LED retract heat P1 – P6 W1 – W3 4 - 6 control dial. Rieber GmbH & Co. KG...
Page 26
▌ After 3 hours of uninterrupted ON time the LED flashes red. ➢ Observe the total permissible regeneration and keep-warm time of 3 hours in accordance with the health requirements, otherwise health impairments can result. 7.5.3 Program settings for regeneration...
Page 27
Turn the power regulator back to ‘0’ at every START. Then select the desired program. ➢ If the power supply is interrupted during the program sequence, the program must be restarted. To do this, turn the power regulator back to ‘0’ and then select the desired program. Rieber GmbH & Co. KG...
Page 28
After 3 hours the total permissible regenerating and keep-warm time according to HACCP is exceeded. ▌ The LED flashes red. ➢ Observe the total permissible regeneration and keep-warm time of 3 hours in accordance with the health requirements, otherwise health impairments can result. Rieber GmbH & Co. KG...
Page 29
1 600 W 2 200 W 1 100 W ▌ The LED lights up red during the cooking time. ➢ ATTENTION ® thermoplate can be damaged by overheating. Please observe the instructions for your ® thermoplate Rieber GmbH & Co. KG...
Lead with connector … ik-… ® # Intended use of the K|POT • For keeping hot food warm, for regenerating pre-prepared dishes, for cooking. • ® Use thermoplate ‘Purpose’, cover sheet page 1, page 13 ‘General mode of operation’, page 20...
Page 31
The purpose of the keep-warm function is to regulate the base of the pot to give a temperature of around 70 °C /65 °C in the pot. This allows food to be kept warm in an energy-optimised manner or gently warmed.
Page 32
The cooking zone can only be restarted after resetting ("zero setting") the power regulator. • The time remaining until automatic shut-off is reset to the initial value after each new operation of the cooking zone. Heat setting: OTL [minutes]: Heat setting: OTL [minutes]: Boost Rieber GmbH & Co. KG...
4 feet, slip-resistant, 20 mm high Retractable power regulator, 0 to 9, and indicator light for displaying the operating state. The keep-cold temperature is continuously variable from +10 °C to –7 °C. ON/OFF rocker switch 5 Power cable with shock-proof plug # Note on use Electronic control for regulating the cold function.
Main switch (ON/OFF switch) + – buttons for adjusting the set point ON/OFF button for switching on and temperature. To do this, keep the SET off. When the unit is switched on, button (2) pressed simultaneously. information appears in the display (6) as well as one of the control indicators SET button.
Page 35
When the operating mode is changed from keep-cold to keep-warm the appliance starts immediately. The keep-warm temperature is adjustable up to +120 °C. When the operating mode is changed from keep-warm to keep-cold, the appliance starts when the stainless steel plate has cooled down to around 40 °C.
Do not use any abrasive or aggressive cleaning agents. ► Use cleaning agents which are suitable for stainless steel. ► Avoid prolonged exposure of stainless steel to sodium chloride solutions. Source: DGUV Regulation 3. Electrical Systems and Equipment Rieber GmbH & Co. KG...
After cleaning, rub surfaces dry with a soft cloth. The cloth should be well rinsed out beforehand. User tip ► We recommend Rieber cleaning agent for stainless steel for cleaning stainless steel. ▌ It is an especially tough yet gentle cleaner, produces a dazzling shine, cleans and protects in one.
Then switch the appliance on again. ‘General mode of operation ’, page 20 Any repairs during warranty period may only be performed by manufacturer´s service department of Rieber. Please contact the manufacturer´s service department of Rieber. Fault Possible cause Rectification ...
use non-original spare parts. The "Sales and delivery terms and conditions" of Rieber GmbH & Co. KG shall apply for all warranty claims made against the manufacturer. For instance, any repairs and/or overhaul during the warranty period may only be performed by the manufacturer´s service department of Rieber, failing which any claims hereof may be voided.
Excerpt from EU Declarations of Conformity # EC Declaration of Conformity according to EC Machinery Directive 2006/42/EC Rieber GmbH & Co. KG herewith declares that the products K|POT ® comply with the basic requirements of the EC Machinery Directive 2006/42/EC, Appendix II A, harmonised standards (DIN EN ISO 12100:2011-03 Safety of machines –...
Need help?
Do you have a question about the K|POT 1/1 ik-3600-2Z and is the answer not in the manual?
Questions and answers