Advertisement
8
DO NOT stand on the heater.
8
DO NOT connect the heater to a timer device or other equipment than can automatically switch the heater on or off.
9
Only use the heater in an upright position.
9
Ensure that the heater is correctly turned off when not in use and store in a safe, dry, childproof location.
NOTE: Children of less than 3 years should be kept away unless supervised continuously.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed
in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and
vulnerable people are present.
2. INTRODUCTION
Portable Industrial heater with a fan only and two heat settings. Tough composite case with integral carry handle. Full range ambient room
thermostat maintains temperature. Fan doubles as cool air blower for use in the summer.
Supplied without plug.
3. SPECIFICATION
Model No: .....................................................................FH3000
Supply: ....................230V~50Hz - 16A (Supplied without plug)
Power: ........................................................................... 3000W
4. OPERATION
4.1.
Position heater in an upright position on a firm surface and at a safe distance from any
obstructions, flammable substances etc. Keep to a minimum of 0.5mtr clearance at the
rear and sides, and 2mtr clearance at the front.
4.2.
Connect the heater to a suitable mains supply.
4.3.
Set thermostat to the required temperature (max. = ~ 100
4.4.
Set the required temperature using the Fan Control dial set to either the ' I ' (lower value)
or ' II ' (higher value) (Fig.2).
4.5.
Once the room reaches the required temperature, turn the thermostat dial slowly
counter-clockwise until the thermostat clicks, leave the dial in this position to maintain
the room temperature at this setting. The heater will continue to operate until the Fan Control is turned to the OFF ' 0 ' position.
4.6.
For fan only operation, turn the Fan Control clockwise to the fan only settings
minimum setting (Fig.2).
4.7.
When not in use, disconnect the heater from the mains supply. Store it in a safe, dry, childproof location.
4.8.
To adjust fan direction, loosen the thumb wheels on the side of the support frame (fig.1) and fully tighten when the required angle is set.
Fan Control
5. MAINTENANCE
‰
WARNING! Before attempting any maintenance, ensure that the unit is unplugged from the mains power supply and that it has cooled down.
5.1.
Clean the heater with a soft dry cloth only. DO NOT use abrasives or solvents.
5.2.
Periodically check the heater grille to ensure that it is not blocked.
No other maintenance is necessary. If a problem with the heater is experienced, or if the power lead or plug is damaged, contact your
local authorised service agent for repair. DO NOT dismantle or tamper with the heater, as this may be dangerous and will invalidate the
warranty.
© Jack Sealey Limited
o
C).
Fig.2
Thermostat
Original Language Version
Thumb Wheel
Adjuster
(low) or
(high), and set the thermostat to its
FH3000
Issue 1
Fig.1
09/06/21
Advertisement
