MILACRON CIMCOOL MIX MASTER PROPORTIONER II Quick Start Manual

CIMCOOL Mix Master II Proportioner (EQ02549) Parts, Exploded View
KEY ITEM NUMBER
1 EQ00151
2 EQ00160
3 EQ00078
4 EQ00159
5 EQ00162
6 EQ00074
7 EQ02246
8 EQ02862
9 EQ00144
10 EQ00075
11 EQ00142
12 EQ00082
13 EQ00168
14 EQ00143
4
3 4
1 2 5
4
7
8
Publication No. PC554-8 3000 Disney Street
Printed in U.S.A. 9/08 Milacron Marketing Company
Cincinnati, Ohio 45209
888-246-2665
FIGURE 2

DESCRIPTION

Strainer Washer (238100)
Hose swivel (506500)
Ball valve (502000)
Street Elbow (505600)
Nipple (505900)
Vacuum Breaker (506300)
Mounting Bracket (6150-K)
Bung Adapter Assy. (Plastic)
(90083030, 90083031, 90083032)
Metering Tip Kit (690015)
Orifice Retainer (441101)
Venturi (Eductor Body) Assy. (441100-CM)
Discharge Hose Assy. (5058-4DA)
Siphon Hose/Foot Valve Assy. (5058-4DM)
Foot Valve Assy. (10076305)
6
5
9
10
11
12
13
14
CIMCOOL MIX MASTER
PROPORTIONER II

WARNING:

Do not use the proportioner
where water pressure exceeds
90 psig (620 KPa). Do not use
the proportioner with a water
supply temperature above
170°F (77°C). Use caution
when handling chemicals;
wear protective eyewear and
gloves to prevent contact with
the chemicals. Failure to follow
these instructions may result in
personal injury.
For more specific information
on the safety of the various
CIMCOOL metalworking flu-
ids, obtain the Product Infor-
mation Folder(s) and follow the
965621
recommendations provided.
Rev. D 9/08
®
Part Number EQ02549
UPC 66250502549

OPERATING INSTRUCTIONS/INSTALLATION GUIDE

D E S C R I P T I O N
The CIMCOOL Mix Master II is a
simple, economical, and accurate
method to mix CIMCOOL metalworking
fluid concentrate with water. The most
important requirement in the use of
metalworking fluids is maintaining the
proper mix ratio. The Mix Master II
siphons concentrate from a 55 gallon
or ( 200 L) drum and mixes it with water
to supply approximately 3 to 4* gallons
per minute of premixed fluid for an
individual machine tool reservoir, central
system, or premix tank. This is
accomplished by a siphoning venturi
operating on water pressure.
The two main requirements for
successful operation of the equipment
are a minimum water pressure of 15
psig (101 KPa) (flow pressure) and
selection of the proper metering tip.
The unit features a vacuum breaker to
prevent backflow of fluid concentrate to
the tap water line (in compliance with
OSHA regulation 29 CFR section
1910.141 (b)(2)(iii)).
The unit also features a foot valve/
strainer to prevent backflow of
concentrate into the drum.
* 3.7 gpm at 40 psig flow pressure (14 LPM at 275 KPa)