Table of Contents
Advertisement
Deflection amplitude setting for 51WH36P (HIT/WID adjusting method under muted convergence)
Deflection amplitude setting for 42/57WH36P
B
A
3rd flag 1st flag
0
C
Horizontal amplitude: Left and right register marks of Philips pattern C + D = 8 (See A of the upper figure.)
Vertical amplitude:
The point where the 3rd vertical line outer from the upper and lower register marks of Philips
pattern is overlapped with flags contacts the screen edge. If the amplitude is uneven horizontally
and vertically, make HIT adjustment so that B shown in the upper left of the upper figure comes to
contact the screen edge.
Next, pay attention to the C point. Check and confirm that the castration border line contacts
through 2nd line to 4th line outer from the lower register mark.
Vertical amplitude adjusting method for PAL/100Hz mode
1 Make adjustment on the basis of the upper screen.
2 Do not make VLIN adjustment for SUPERLIVE.
3 Screen adjusting range: ±1
* Green pattern under the muted convergence
Screen edge
0 point
Castration border line
– 20 –
A
WIDE
SUPERLIVE
SUBTITLE
CINEMA
Advertisement
Table of Contents
