Table of Contents
Advertisement
11.7 Cycle time recalculation
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the cycle
time to the laundry you
have put in the drum to
have perfect washing
results in the minimum
necessary time.
• The display shows the
new time value.
11.8 Starting a programme
with the delay start
1. Press button Ajastin again and again
until the display shows the number of
minutes or hours of delay.
The related indicator comes on.
2. Press button Käynnistä/Tauko.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
Käynnistä/Tauko to start the
appliance, you can cancel or
change the set of the delay
start.
11.9 Cancelling the delay
start
To cancel the delay start:
1. Press button Käynnistä/Tauko to set
the appliance to pause.
The related indicator flashes.
2. Press button Ajastin repeatedly until
the display shows .
3. Press button Käynnistä/Tauko again
to start the programme immediately.
11.10 Interrupting a
programme and changing a
option
You can change only some options
before they operate.
1. Press button Käynnistä/Tauko.
The related indicator flashes.
2. Change the option set.
3. Press the button Käynnistä/Tauko
again.
The programme continues.
11.11 Cancelling a running
programme
1. Press button Päällä/Pois to cancel
the programme and to deactivate the
appliance.
2. Press button Päällä/Pois again to
activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
11.12 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Käynnistä/Tauko
button, the maximum declared load
indicator goes off, the indicator
flashes, the ProSense starts the laundry
load detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
the time dots flash, the drum rotates
shortly.
2. At the end of the load detection, the
indicator
goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
ENGLISH
23
and
is
Advertisement
Table of Contents
